검색결과 : 8건
| No. | Article |
|---|---|
| 1 |
Critical heat flux tests for an application of the three-pin fuel test loop in HANARO Choi KY, Moon SK, Chun S, Park JK, Hwang DH, Baek WP, Park SK, Lee CY Heat Transfer Engineering, 29(8), 685, 2008 |
| 2 |
The experimental study on mixing characteristics in a square subchannel geometry with typical flow deflectors Chang SK, Moon SK, Baek WP, Chun TH Heat Transfer Engineering, 29(8), 695, 2008 |
| 3 |
Comparison of the CHF data for water and refrigerant HFC-134a by using the fluid-to-fluid modeling methods Chun SY, Hong SD, Cho YS, Baek WP International Journal of Heat and Mass Transfer, 50(21-22), 4446, 2007 |
| 4 |
Modeling of the condensation sink term in an interfacial area transport equation Park HS, Lee TH, Hibiki T, Baek WP, Ishii M International Journal of Heat and Mass Transfer, 50(25-26), 5041, 2007 |
| 5 |
Modeling capability of R134a for a critical heat flux of water in a vertical 5 x 5 rod bundle geometry Akhtar SW, Moon SK, Chun SY, Hong SD, Baek WP International Journal of Heat and Mass Transfer, 49(7-8), 1299, 2006 |
| 6 |
Visualization of a principle mechanism of critical heat flux in pool boiling Bang IC, Chang SH, Baek WP International Journal of Heat and Mass Transfer, 48(25-26), 5371, 2005 |
| 7 |
Visualization of the subcooled flow boiling of R-134a in a vertical rectangular channel with an electrically heated wall Bang IC, Chang SH, Baek WP International Journal of Heat and Mass Transfer, 47(19-20), 4349, 2004 |
| 8 |
Non-heating simulation of pool-boiling critical heat flux Jeong YH, Baek WP, Chang SH International Journal of Heat and Mass Transfer, 45(19), 3987, 2002 |