| 1 |
Molecular Orientation Distributions During Injection Molding of Liquid Crystalline Polymers: Ex Situ Investigation of Partially Filled Moldings
Fang J, Burghardt WR, Bubeck RA
Polymer Engineering and Science, 52(4), 774, 2012 |
| 2 |
Bulk and Surface Molecular Orientation Distribution in Injection-Molded Liquid Crystalline Polymers: Experiment and Simulation
Fang J, Burghardt WR, Bubeck RA, Burgard SM, Fischer DA
Polymer Engineering and Science, 50(9), 1864, 2010 |
| 3 |
Polydomain Model Predictions of Molecular Orientation in Isothermal Channel Flows of Thermotropic Liquid Crystalline Polymers
Fang J, Burghardt WR, Bubeck RA
Polymer Engineering and Science, 48(11), 2258, 2008 |
| 4 |
Interrogation of "surface," "skin," and "core" orientation in thermotropic liquid-crystalline copolyester moldings by near-edge x-ray absorption fine structure and wide-angle x-ray scattering
Rendon S, Bubeck RA, Thomas LS, Burghardt WR, Hexemer A, Fischer DA
Journal of Applied Polymer Science, 106(4), 2502, 2007 |
| 5 |
Orientation dynamics in commercial thermotropic liquid crystalline polymers in transient shear flows
Rendon S, Burghardt WR, Bubeck RA
Rheologica Acta, 46(7), 945, 2007 |
| 6 |
Characterization of the skin orientation of thermotropic liquid-crystalline copolyester moldings with near-edge X-ray absorption fine structure
Bubeck RA, Thomas LS, Rendon S, Burghardt WR, Hexemer A, Fischer DA
Journal of Applied Polymer Science, 98(6), 2473, 2005 |
| 7 |
Mechanical and morphological anisotropy in injection molding of thermotropic liquid crystalline copolyesters
Rendon S, Burghardt WR, Bubeck RA, Thomas LS, Hart B
Polymer, 46(23), 10202, 2005 |
| 8 |
Effect of complex flow kinematics on the molecular orientation distribution in injection molding of liquid crystalline copolyesters
Rendon S, Burghardt WR, New A, Bubeck RA, Thomas LS
Polymer, 45(15), 5341, 2004 |
| 9 |
In-situ synchrotron WAXD/SAXS studies of structural development during PBO/PPA solution spinning
Ran SF, Burger C, Fang DF, Zong XH, Cruz S, Chu B, Hsiao BS, Bubeck RA, Yabuki K, Teramoto Y, Martin DC, Johnson MA
Macromolecules, 35(2), 433, 2002 |
| 10 |
Injection blow molding technology for polyethylene terephthalate
Bubeck RA, Barger MA
International Polymer Processing, 15(4), 337, 2000 |
