| 1 |
The challenges of a Li-ion starter lighting and ignition battery: A review from cradle to grave
Ferg EE, Schuldt F, Schmidt J
Journal of Power Sources, 423, 380, 2019 |
| 2 |
Comparative capacity performance and electrochemical impedance spectroscopy of commercial AA alkaline primary cells
Ferg EE, van Vuuren F
Electrochimica Acta, 128, 203, 2014 |
| 3 |
The use of a Polymat material to reduce the effects of sulphation damage occurring in negative electrodes due to the partial state of charge capacity cycling of lead acid batteries
Snyders C, Ferg EE, van Dyl T
Journal of Power Sources, 200, 102, 2012 |
| 4 |
Characterisation and long-term usage catalytic properties of (VO)(2)P2O7/gamma-Al2O3 stainless steel coated catalyst in p-cymene oxidation
Makgwane PR, Ferg EE, Zeelie B
Applied Catalysis A: General, 373(1-2), 132, 2010 |
| 5 |
Liquid Phase Oxidation of p-cymene by (VO)(2)P2O7 and VO(PO3)(2) Catalysts
Makgwane PR, Ferg EE, Billing DG, Zeelie B
Catalysis Letters, 135(1-2), 105, 2010 |
| 6 |
Selective oxidation of p-cymene catalyzed by VPO catalyst: Process performance and kinetics studies
Makgwane PR, Harmse NI, Ferg EE, Zeelie B
Chemical Engineering Journal, 162(1), 341, 2010 |
| 7 |
A new look at determining acid absorption of lead oxide used in the manufacturing of Pb-acid batteries
Ferg EE, Phangalala T, van Dyl T
Journal of Applied Electrochemistry, 40(2), 383, 2010 |
| 8 |
The addition of red lead to flat plate and tubular valve regulated miners cap lamp lead-acid batteries
Ferg EE, Loyson P, Poorun A
Journal of Power Sources, 155(2), 428, 2006 |
| 9 |
Porosity measurements of electrodes used in lead-acid batteries
Ferg EE, Loyson P, Rust N
Journal of Power Sources, 141(2), 316, 2005 |
| 10 |
The influence of the pickling and curing processes in the manufacturing of positive tubular electrodes on the performance of lead-acid batteries
Ferg EE, Geyer L, Poorun A
Journal of Power Sources, 116(1-2), 211, 2003 |
