| 1 |
Injection moulding of porous MAX phase Ti3SiC2 without using space-holder
Tabares E, Cifuentes SC, Jimenez-Morales A, Tsipas SA
Powder Technology, 380, 96, 2021 |
| 2 |
Molding properties of titanium-based feedstock used in low-pressure powder injection molding
Ghanmi O, Demers V
Powder Technology, 379, 515, 2021 |
| 3 |
Fabrication of titanium components by low-pressure powder injection moulding using hydride-dehydride titanium powder
Moghadam MS, Fayyaz A, Ardestani M
Powder Technology, 377, 70, 2021 |
| 4 |
Numerical simulation and experimental investigation of mold filling and segregation in low-pressure powder injection molding of metallic feedstock
Ben Trad MA, Demers V, Cote R, Sardarian M, Dufresne L
Advanced Powder Technology, 31(3), 1349, 2020 |
| 5 |
Effect of 17-4PH stainless steel powders interaction on feedstocks
Ma HH, Li S, Jin ZS, Tian YW, Ren FM, Zhou ZF, Xu WB
Powder Technology, 372, 204, 2020 |
| 6 |
Investigation and two-stage modeling of sintering behavior of nano/micro-bimodal powders
Oh JW, Seong Y, Shin D, Park SJ
Powder Technology, 352, 42, 2019 |
| 7 |
Optimizing hydride-dehydride Ti-6Al-4V feedstock composition for titanium powder injection moulding
Thavanayagam G, Swan JE
Powder Technology, 355, 688, 2019 |
| 8 |
Experimental study on moldability and segregation of Inconel 718 feedstocks used in low-pressure powder injection molding
Demers V, Fareh F, Turenne S, Demarquette NR, Scalzo O
Advanced Powder Technology, 29(1), 180, 2018 |
| 9 |
Effect of binder composition on rheological behavior of PMN-PZT ceramic feedstock
Park JM, Han JS, Gal CW, Oh JW, Kate KH, Atre SV, Kim Y, Park SJ
Powder Technology, 330, 19, 2018 |
| 10 |
Powder distribution on powder injection moulding of ceramic green compacts using thermogravimetric analysis and differential scanning calorimetry
Poh L, Della C, Ying SJ, Goh C, Li Y
Powder Technology, 328, 256, 2018 |
