| 1 |
Experimental Study on the Filling of Nano Structures with Infrared Mold Surface Heating
Lin HY, Chang CH, Young WB
International Polymer Processing, 26(1), 73, 2011 |
| 2 |
The Filling Behavior of Reinforcing Glass Fiber in Micro Injection Molding
Liou GL, Young WB
International Polymer Processing, 25(4), 264, 2010 |
| 3 |
Study on Mold Filling Behaviors of Micro Channels in Injection Molding
Li JH, Young WB
International Polymer Processing, 24(5), 421, 2009 |
| 4 |
Analysis of the isothermal compression in nanoimprint lithography assuming a power-law fluid
Hsin IC, Young WB
International Polymer Processing, 23(1), 24, 2008 |
| 5 |
Analysis of the residual stresses in the process of nanoimprint lithography
Young WB
International Polymer Processing, 21(3), 290, 2006 |
| 6 |
Experimental study on the filling of a micro injection molding with cylindrical dot patterns
Chang HC, Young WB
International Polymer Processing, 20(3), 245, 2005 |
| 7 |
Three dimensional analysis of shape deformation in injection molded optical lens
Young WB
International Polymer Processing, 19(1), 70, 2004 |
| 8 |
Microinjection molding with LIGA-Like process
Yang SP, Young WB
International Polymer Processing, 19(2), 180, 2004 |
| 9 |
Capillary impregnation into cylinder banks
Young WB
Journal of Colloid and Interface Science, 273(2), 576, 2004 |
| 10 |
On the residual stress and shrinkage in injection compression molding
Young WB
International Polymer Processing, 18(3), 313, 2003 |
