| 1 |
Fabrication of multi-filler thermoset-based composite bipolar plates for PEMFCs applications: Molding defects and properties characterizations
Simaafrookhteh S, Khorshidian M, Momenifar M
International Journal of Hydrogen Energy, 45(27), 14119, 2020 |
| 2 |
Kafirin-derived films for sustainable development by amidation and esterification
Mahajan UR, Mhaske ST
Polymer Bulletin, 77(5), 2719, 2020 |
| 3 |
크림프가 없는 탄소섬유직물/에폭시 복합재료의 동역학, 인장, 굴곡 및 충격 특성에 미치는 프리프레그 Angle-Ply의 영향
정나은, 조동환
Polymer(Korea), 44(1), 61, 2020 |
| 4 |
Enhanced impact strength of injection-compression molded parts by controlling residual stress distribution
Oh HJ, Song YS
Korea-Australia Rheology Journal, 31(1), 35, 2019 |
| 5 |
Direct replication of micro-nanostructures in the fabrication of superhydrophobic silicone rubber surfaces by compression molding
Maghsoudi K, Momen G, Jafari R, Farzaneh M
Applied Surface Science, 458, 619, 2018 |
| 6 |
Effects of different pretreatments on compression molding of wheat straw and mechanism analysis
Zhang XY, Peng WQ, Han LJ, Xiao WH, Liu X
Bioresource Technology, 251, 210, 2018 |
| 7 |
Simulation of injection-compression molding for thin and large battery housing
Kwon YI, Lim E, Song YS
Current Applied Physics, 18(11), 1451, 2018 |
| 8 |
Structural optimization of graphite for high-performance fluorinated ethylene-propylene composites as bipolar plates
Lee MH, Kim HY, Oh SM, Kim BC, Bang D, Han JT, Woo JS
International Journal of Hydrogen Energy, 43(48), 21918, 2018 |
| 9 |
Application of injection-compression molding to thin-walled polymeric parts
Kwon YI, Song YS
Korea-Australia Rheology Journal, 30(3), 161, 2018 |
| 10 |
Rapid fabrication of antireflective pyramid structure on polystyrene film used as protective layer of solar cell
Peng YJ, Huang HX, Xie H
Solar Energy Materials and Solar Cells, 171, 98, 2017 |
