| 1 |
Determination of the optimal axial-to-radial flow ratio of the wall-mounted swirling ventilation in fully mechanized excavation face
Li YJ, Wang PF, Liu RH, Jiang YD, Han H
Powder Technology, 360, 890, 2020 |
| 2 |
CFD-based optimization of the installation location of the wall-mounted air duct in a fully mechanized excavation face
Wang PF, Gao RZ, Liu RH, Yang FQ
Process Safety and Environmental Protection, 141, 234, 2020 |
| 3 |
Numerical study of gas-solid two-phase flow around road-header drivers in a fully mechanized excavation face
Hu SY, Liao Q, Feng GR, Huang YS, Shao H, Fan YR, Ye YB
Powder Technology, 344, 959, 2019 |
| 4 |
Optimization of structural parameters and installation position of the wall-mounted air cylinder in the fully mechanized excavation face based on CFD and orthogonal design
Li YJ, Wang PF, Liu RH, Gao RZ
Process Safety and Environmental Protection, 130, 344, 2019 |
| 5 |
An investigation of the nozzle's atomization dust suppression rules in a fully-mechanized excavation face based on the airflow-droplet-dust three-phase coupling model
Yu HM, Cheng WM, Peng HT, Xie Y
Advanced Powder Technology, 29(4), 941, 2018 |
| 6 |
Formation mechanisms of a dust-removal air curtain in a fully-mechanized excavation face and an analysis of its dust-removal performances based on CFD and DEM
Yu HM, Cheng WM, Wang H, Peng HT, Xie Y
Advanced Powder Technology, 28(11), 2830, 2017 |
| 7 |
The diffusion and pollution mechanisms of airborne dusts in fully-mechanized excavation face at mesoscopic scale based on CFD-DEM
Cheng WM, Yu HM, Zhou G, Nie W
Process Safety and Environmental Protection, 104, 240, 2016 |
