3379 - 3386 |
Comparison of numerical and experimental performance criteria of an ammonia-water bubble absorber using plate heat exchangers Cerezo J, Best R, Bourouis M, Coronas A |
3387 - 3393 |
Modeling of microwave heating of andesite and minerals Lovas M, Kovacova M, Dimitrakis G, Cuvanova S, Znamenackova I, Jakabsky S |
3394 - 3404 |
Heat flux dispersion in natural convection in porous media Vadasz P |
3405 - 3413 |
The effect of a surfactant monolayer on oxygen transfer across an air/water interface during mixed convection Lee RJ, Saylor JR |
3414 - 3428 |
Performance of naphthalene thermosyphons with non-condensable gases -Theoretical study and comparison with data Mantelli MBH, Angelo WB, Borges T |
3429 - 3438 |
In situ High Temperature Heat Flux Sensor Calibration Pullins CA, Diller TE |
3439 - 3448 |
A four-zone model for saturated flow boiling in a microchannel of rectangular cross-section Wang GD, Hao LA, Cheng P |
3449 - 3459 |
Flow mechanisms of HFC-410A inside short-tube orifices during flashing process Nilpueng K, Wongwises S |
3460 - 3470 |
Inverse estimation of inlet parameters in diffusion-controlled turbulent combustion in an axisymmetric combustor Lee KH, Baek SW |
3471 - 3482 |
Operational characteristics of the miniature loop heat pipe with non-condensable gases Singh R, Akbarzadeh A, Mochizuki M |
3483 - 3494 |
Unsteady heat transfer from an oblate/prolate spheroid Juncu G |
3495 - 3502 |
Heat and mass transfer in evaporating droplets in interaction: Influence of the fuel Depredurand V, Castanet G, Lemoine F |
3503 - 3512 |
Study of a thermoelement's behaviour through a modelling based on electrical analogy Fraisse G, Lazard M, Goupil C, Serrat JY |
3513 - 3524 |
Radiative effects on natural convection in vertical convergent channels Bianco N, Langellotto L, Manca O, Nardini S |
3525 - 3532 |
Heat transfer and void fraction profiles around a horizontal cylinder immersed in a bubbling fluidised bed Di Natale F, Bareschino P, Nigro R |
3533 - 3539 |
The effect of local thermal non-equilibrium on forced convection boundary layer flow from a heated surface in porous media Celli M, Rees DAS, Barletta A |
3540 - 3551 |
Improving the accuracy of heat balance integral methods applied to thermal problems with time dependent boundary conditions Mitchell SL, Myers TG |
3552 - 3561 |
Effect of cycling rate, particle size and transport properties on lithium-ion cathode performance Du WB, Gupta A, Zhang XC, Sastry AM, Shyy W |
3562 - 3569 |
Effects of inlet geometry on heat transfer and fluid flow of tangential micro-heat sink Lelea D |
3570 - 3574 |
Fractal analysis of Herschel-Bulkley fluid flow in porous media Yun MJ, Yu BM, Lu JD, Zheng W |
3575 - 3584 |
Flow structure and heat transfer induced by embedded vorticity Kaci HM, Habchi C, Lemenand T, Della Valle D, Peerhossaini H |
3585 - 3591 |
Numerical analysis and thermographic investigation of induction heating Kranjc M, Zupanic A, Miklavcic D, Jarm T |