| 11395 - 11408 |
Green hydrogen as feedstock: Financial analysis of a photovoltaic-powered electrolysis plant
Nicita A, Maggio G, Andaloro APF, Squadrito G |
| 11409 - 11423 |
Charging Chinese future: the roadmap of China's policy for new energy automotive industry
Li JZ |
| 11424 - 11437 |
Exergy analysis for the Na-O-H (sodium-oxygen-hydrogen) thermochemical water splitting cycle
Marques JGO, Costa AL, Pereira C |
| 11438 - 11448 |
Numerical and experimental study on hydrogen production via dimethyl ether steam reforming
Zhang TQ, Choi B, Kim YB |
| 11449 - 11459 |
New low cost mesoporous silica (MSN) as a promising support of Ni-catalysts for high-hydrogen generation via dry reforming of methane (DRM)
Mourhly A, Kacimi M, Halim M, Arsalane S |
| 11460 - 11470 |
Technico-economic analysis of off grid solar PV/Fuel cell energy system for residential community in desert region
Ghenai C, Salameh T, Merabet A |
| 11471 - 11483 |
Techno-economic analysis for rustic electrification in Egypt using multi-source renewable energy based on PV/ wind/ FC
Samy MM, Barakat S, Ramadan HS |
| 11484 - 11491 |
Triple hybrid system coupling fuel cell with wind turbine and thermal solar system
Haddad A, Ramadan M, Khaled M, Ramadan HS, Becherif M |
| 11492 - 11501 |
Electrodeposited Cr-Doped alpha-Fe2O3 thin films active for photoelectrochemical water splitting
Bouhjar F, Derbali L, Mari B, Bessais B |
| 11502 - 11511 |
MoS2-mesoporous LaFeO3 hybrid photocatalyst: Highly efficient visible-light driven photocatalyst
Acharya S, Swain G, Parida KM |
| 11512 - 11526 |
Comparative study of hydrogen production from steam reforming of acetic acid over synthesized catalysts via MOF and wet impregnation methods
Kumar A, Sinha ASK |
| 11527 - 11537 |
Optimal sizing of wind-hydrogen system considering hydrogen demand and trading modes
Deng ZH, Jiang YW |
| 11538 - 11549 |
Anaerobic co-digestion of petroleum hydrocarbon waste and wastewater treatment sludge
Janajreh I, Alshehi A, Elagroudy S |
| 11550 - 11558 |
Mathematical modeling of the anaerobic digestion in two-stage system with production of hydrogen and methane including three intermediate products
Chorukova E, Simeonov I |
| 11559 - 11568 |
Assessment of laminar flame velocity of producer gas from biomass gasification using the Bunsen burner method
Andrade RV, Castaneda LAC, Maya DMY, Correa PSPC, Pinto LRME, Lora EES, Oliveira CAVBD, Pinto BA |
| 11569 - 11576 |
Characteristics of methane and bioflocculant production by Methanosarcina spelaei RK-23
Zhao HJ, Zheng YL, Zhou S, Liu L, Zhou JG, Sun S |
| 11577 - 11592 |
Production of hydrogen-rich syngas from novel processes for gasification of petroleum cokes and coals
Al-Zareer M, Dincer I, Rosen MA |
| 11593 - 11604 |
Hydrogen-rich syngas production and carbon dioxide formation using aqueous urea solution in biogas steam reforming by thermodynamic analysis
Lin KW, Wu HW |
| 11605 - 11614 |
Catalytic deoxygenation of triolein to green fuel over mesoporous TiO2 aided by in situ hydrogen production
Oi LE, Choo MY, Lee HV, Taufiq-Yap YH, Cheng CK, Juan JC |
| 11615 - 11624 |
InP/TiO2 heterojunction for photoelectrochemical water splitting under visible-light
Niu M, Cao DP, Sui KY, Liu CZ |
| 11625 - 11631 |
First hydrogenation kinetics of Zr and Mn doped TiFe alloy after air exposure and reactivation by mechanical treatment
Manna J, Tougas B, Huot J |
| 11632 - 11640 |
Thermodynamic and microstructural basis for the fast hydrogenation kinetics in Mg-Mg2Ni-carbon hybrids
Gupta A, Faisal M, Shervani S, Balani K, Subramaniam A |
| 11641 - 11650 |
La(OH)(3)-decorated NiFe nanoparticles as efficient catalyst for hydrogen evolution from hydrous hydrazine and hydrazine borane
Zou HT, Guo F, Luo MH, Yao QL, Lu ZH |
| 11651 - 11661 |
Fly ash as catalyst support material in the hydrolysis of ethylenediamine bisborane for hydrogen production: The use of coal-fired power plant waste
Onder A, Ozay O |
| 11662 - 11674 |
Effects of stress and defects on hydrogenation and magnetic properties in (111) fiber-textured palladium cobalt alloy films
Harumoto T, Shi J, Nakamura Y |
| 11675 - 11685 |
Preparation and electrochemical hydrogen storage properties of Ti49Zr26Ni25 alloy covered with porous polyaniline
Liu H, Liu WQ, Sun Y, Chen P, Zhao JX, Guo X, Su ZM |
| 11686 - 11694 |
Thermodynamic and corrosion study of Sm1-xMgxNiy (y=3.5 or 3.8) compounds forming reversible hydrides
Charbonnier V, Madern N, Monnier J, Zhang J, Paul-Boncour V, Latroche M |
| 11695 - 11703 |
Control of solid oxide fuel cells damage using infrared thermography
El-Amiri A, Saifi A, Elhassnaoui A, Obbadi A, Errami Y, Sahnoun S |
| 11704 - 11713 |
Innovative cathode flow-field design for passive air-cooled polymer electrolyte membrane (PEM) fuel cell stacks
Lee J, Gundu MH, Lee N, Lim K, Lee SW, Jang SS, Kim JY, Ju H |
| 11714 - 11732 |
Numerical study for diagnosing various malfunctioning modes in PEM fuel cell systems
Chinannai MF, Lee J, Ju H |
| 11733 - 11748 |
Effect of PEM fuel cell exhaust water conductivity on catalyst degradation using thermal degradation resistant polymer membranes
Burye TE |
| 11749 - 11760 |
Deposition of nanostructured LSM perovskite thin film on dense YSZ substrate by airbrushed solution combustion (ASC) for application in SOFC cathodes
Tarrago DP, Moreno B, Chinarro E, Malfatti CD, de Sousa VC |
| 11761 - 11772 |
Aging prognosis model of proton exchange membrane fuel cell in different operating conditions
Chen K, Laghrouche S, Djerdir A |
| 11773 - 11783 |
Thermally crosslinked and quaternized polybenzimidazole ionomer binders for solid alkaline fuel cells
Shin MS, Lim S, Park JH, Kim HJ, Chae S, Park JS |
| 11784 - 11790 |
Influence of anode's microstructure on electrochemical performance of solid oxide direct carbon fuel cells
Liu C, Pu JG, Chen X, Ma Z, Ding X, Zhou J, Wang SR |
| 11791 - 11801 |
Novel in-situ MgO nano-layer decorated carbon-tolerant anode for solid oxide fuel cells
Xie Y, Shi N, Hu XY, Liu MQ, Yang Y, Huan DM, Pan Y, Peng RR, Xia CR |
| 11802 - 11813 |
Effect of Fe, Ni and Zn dopants in La0.9Sr0.1CoO3 on the electrochemical performance of single-component solid oxide fuel cell
Li P, Yang QY, Zhang H, Yao MX, Yan F, Fu D |
| 11814 - 11823 |
Synthesizing spindle-shaped anion exchange membranes to improve conductivity and stability
Du XM, Zhang HY, Yuan YJ, Wang Z, Xu JM |
| 11824 - 11833 |
A novel core-shell LSCF perovskite structured electrocatalyst with local hetero-interface for solid oxide fuel cells
Wang L, Wang PP, Geng CL, Cao H, Xu CX, Cheng JG, Hong T |
| 11834 - 11841 |
Enhanced reliability of planar-type solid oxide fuel cell stack incorporating leakage gas induction channels
Kim S, Jang I, Kim C, Lee H, Song T, Yoon H, Paik U |
| 11842 - 11854 |
Overall efficiency comparison between the fueling methods of SAEJ2601 using dynamic simulations
Chochlidakis CG, Rothuizen ED |
| 11855 - 11865 |
Preliminary hazard identification for risk assessment on a complex system for hydrogen production
Hadef H, Negrou B, Ayuso TG, Djebabra M, Ramadan M |
| 11866 - 11874 |
The influence of a crimped-ribbon plate on gaseous explosion characteristics in a closed vessel
Liu R, Wang LQ, Pan J, Ma HH, Shen ZW |
| 11875 - 11884 |
Olfactory appraisal of odorants for 100% hydrogen networks
Mouli-Castillo J, Bartlett S, Murugan A, Badham P, Wrynne A, Haszeldine S, Wheeldon M, McIntosh A |
| 11885 - 11887 |
Conference report-8th international conference on hydrogen and fuel cells during 8th-10th December 2019 at Hotel Ramada Juhu Mumbai, India
Sharma A |
| 11888 - 11888 |
Improved hydrogen storage properties of TiFe alloy by doping (Zr+2V) additive and using mechanical deformation (vol 44, pg 27843, 2019)
Lv P, Liu ZC, Dixit V, Huot J |
