International Polymer Processing

International Polymer Processing, Vol.13, No.1 Entire volume, number list

ISSN: 0930-777X (Print)

In this Issue (19 articles)

2 - 2	Joseph A. Biesenberger (1935-1998) White JL
2 - 2	Giovanni Astarita (1933-1997) White JL
2 - 2	Donald C. Bogue (1932-1997) White JL
3 - 8	Modeling solids conveying in polymer extruders Yamamuro JA, Penumadu D, Campbell A
9 - 12	Comparison between LDPE conventional and autothermal extrusion characteristics Sikora JW
13 - 22	Transesterification of ethylene acetate copolymer in a twin screw extruder - Experimental and theoretical approaches Berzin F, Vergnes B
23 - 26	Stabilising the structure of HDPE by the use of highly-dispersed mixture of Fe/FeO Ozden S
27 - 32	Pumping characteristics of an intermeshing co-rotating twin screw extruder Wang NH, Sakai T, Hashimoto N
33 - 39	Flow behaviour of blends of poly(ethylene-Co-acrylic acid) and epoxidised natural rubber Mohanty S, Bhattacharya AK, Nando GB, Gupta BR
40 - 45	Rheological behaviour of HDPE/PA 11 blends Dospisil D, Kubat J, Saha P, Pavlinek V, Becker J
46 - 49	Melt flow properties of LDPE/HDPE blends in capillary extrusion Liang JZ, Li RKY, Tjong SC
50 - 57	Rheological behaviour of LLDPE/LDPE blends under elongational deformation - Effect of temperature Micic P, Bhattacharya SN, Field G
58 - 66	Processing/structure relationships of mica-filled PE-films with low oxygen permeability Xanthos M, Faridi N, Li Y
67 - 70	On the charge state of melt-blown polymer materials Pinchuk LS, Kravtsov AG, Voronezhtsev YI, Gromyko YV
71 - 77	Temperature measuring in plastics processing with infrared radiation thermometers - The influence of the absorption coefficient Obendrauf W, Langecker GR, Friesenbichler W
78 - 87	Comparative study of structure development in melt spinning polyolefin fibers Choi CH, White JL
88 - 90	Sintering rheology of semi-crystalline polymers Liu SJ
91 - 98	Melt flow instabilities of filled HDPE Dospisil D, Kubat J, Saha P, Trlica J, Becker J
99 - 104	Experimental validation of shrinkage predictions for injection molded products Jansen KMB, van Dijk DJ, Burgers EV