| 2 - 8 |
Research on Influencing Factors of the Thermal Contact Resistance in Thin-Wall Injection Molding
Zhu LY, Wu WQ, Jiang L, Jiang BY |
| 9 - 19 |
Kinetic Analysis on Thermal Decomposition of Poly(lactic acid) Toughened by Calcium Sulfate Whiskers
Yang JN, Nie SB, Chen K, Tao YL, Zhu JB |
| 20 - 29 |
Fabrication of Double-Sided Micro-Lens Array Using UV Injection Molding
Chen XL, Ke KC, Chang NW, Chen YH, Yang SY |
| 30 - 36 |
UV Pre-Treatment for Polycarbonate for Bonding LSR in a Multi-Component Injection Molding Process
Schlitt CU, Hartung M, Ruppel A, Giesen RU, Heim HP |
| 37 - 46 |
Simulations of Heat Transfer in Thermoplastic Injection Molds Manufactured by Additive Techniques
Sardo L, Daidoul W, Vincent M, Toulorge T |
| 47 - 58 |
Cyclic Extrusion of Recycled High Density Polyethylene/Banana Fiber/Fly Ash Cenosphere Biocomposites: Thermal and Mechanical Retention Properties
Satapathy S |
| 59 - 71 |
Effects of Zinc Borate on the Flame Retardancy Performance of Aluminum Diethylphosphinate in Polyamide-6 and its Composites
Polat O, Kaynak C |
| 72 - 80 |
Theoretical and Experimental Studies on Tribological Behavior of Luffa Fiber Reinforced Polyester under the Influence of Surface Treatment
Kalusuraman G, Siva I, Kumar SA |
| 81 - 90 |
Global Modeling of Single Screw Extrusion with Slip Effects
Lewandowski A, Wilczynski K |
| 91 - 99 |
A Closer Look at the Bonding Capacity of Thick Metal-Plastic Hybrids
Weber J, Heim HP |
| 100 - 110 |
Thermomechanical Degradation of Polyetherimide (PEI) by Friction-Based Joining and the Effects on Quasi-Static Mechanical Strength of Hybrid Joints
Sonego M, Abibe AB, Canevarolo SV, Bettini SHP, dos Santos JF, Canto LB, Amancio ST |
| 111 - 120 |
Thermal, Tensile, Electrical, Dynamic Mechanical Thermal and Rheological Properties of Polyvinylidene Fluoride and Fluoroelastomer Composites Filled with Carbon Black
Moezzi MD, Karrabi M, Jahani Y |
| 121 - 132 |
Effect of Zinc Borate on Enhancing Flame Retardancy of Electron Beam Irradiated Alumina Trihydrate (ATH)/Acrylonitrile Butadiene Styrene (ABS) Composites
Bee ST, Sin LT, Ch'ng BS, Ratnam CT, Rahmat AR |
| 133 - 142 |
Could Alfa Fibers Substitute Glass Fibers in Composite Materials?
Abdallah Y, Ben Cheikh R, Paiva MC |
| 143 - 151 |
Analysis of a Single-Screw Extruder with a Grooved Plasticizing Barrel - Experimental Investigation
Kettemann J, Avila-Alfaro JA, Bonten C |
