| 98 - 103 |
Pressure and temperature dependence of LDPE viscosity and free volume: The effect of molecular structure
Sedlacek T, Lengalova A, Zatloukal M, Cermak R, Saha P |
| 104 - 115 |
Correlations between injection molding parameters, morphology and mechanical properties of PPS using artificial neural networks
Lotti C, Bretas RES |
| 116 - 120 |
Investigations into kinematic reversal in non-isothermal flows in single-screw machines
Potente H, Bornemann M, Heinrich D, Pape J |
| 121 - 131 |
The effect of post-extrusion conditions in ribbon extrusion of polymer blends
Ramirez-Arreola D, Padilla-Lopez H, Gonzalez-Nunez R, Rodrigue D |
| 132 - 140 |
Effect of the chemical and morphological conditions of the die wall on the extrusion of linear polyolerins
Larrazabal HJ, Hrymak AN, Vlachopoulos J |
| 141 - 148 |
Investigation of the heat affected zone of hot-gas welded PP joints
Marczis B, Czigany T |
| 149 - 154 |
Method for the optimisation of screw elements for tightly intermeshing, co-rotating twin screw extruders
Potente H, Thumen A |
| 155 - 163 |
Rheology and processing of molten poly(methyl methacrylate) resins
Stamboulides C, Hatzikiriakos SG |
| 164 - 167 |
PLLA morphology controlled by dry-cast process
Meng B, Cui FZ, Cai Q, Zhang Y |
| 168 - 174 |
Two component injection molding of phase separating blends
Keestra BJ, Anderson PD, Meijer HEH |
| 175 - 182 |
A low force valve for dynamic control of molten plastics in a mold
Kazmer DO, Gupta D |
| 183 - 188 |
Influence of drawing and temperature on the optical and structural properties of monofilament PP sutures
Seisa EA |
| 189 - 197 |
Mechanical properties of rubber-toughened post-industrial glass-fiber-reinforced PA 66
Alsewailem FD, Gupta RK |
| 198 - 210 |
Thermal flow instability in metal injection molding: Experiment and simulation
Stevenson JF, Ilinca F |
| 211 - 217 |
State of the art: Recycling of EPDM rubber vulcanizates
Sutanto P, Picchioni E, Janssen LPBM, Dijkhuis KAJ, Dierkes WK, Noordermeer JWM |
