| 228 - 237 |
Assessment of the degree of mixedness of filled polymers
Erol M, Kalyon DM |
| 238 - 244 |
Numerical analysis of rubber moulding using finite element modelling
Hanspal NS, Nassehi V, Ghoreishy MHR |
| 245 - 249 |
Experimental study on the filling of a micro injection molding with cylindrical dot patterns
Chang HC, Young WB |
| 250 - 256 |
The gloss of injection-moulded recovered polypropylene
Pisciotti F, Boldizar A, Rigdahl M |
| 257 - 264 |
Injection moulding and mechanical properties of recovered polypropylene
Pisciotti F, Boldizar A, Rigdahl M |
| 265 - 273 |
Advanced finite element 3D injection molding
Silva L, Gruau C, Agassant JF, Coupez T, Mauffrey J |
| 274 - 285 |
Using multi-objective evolutionary algorithms to optimize mechanical properties of injection molded parts
Gaspar-Cunha A, Viana JC |
| 286 - 295 |
On PVT and rheological measurements of polymer melts - Correction of the hole fraction-viscosity relationship
Sedlacek T, Cermak R, Hausnerova B, Zatloukal M, Boldizar A, Saha P |
| 296 - 304 |
External calibration in PA12 tube extrusion - Part I: On-line draw ratio measurement and lubrication estimate for determination of tensile properties
Carin A, Haudin JM, Vincent M, Monasse B, Bellet G, Silagy D |
| 305 - 311 |
External calibration in PA12 tube extrusion - Part II: Relations between molecular orientation, tensile properties and polymer drawing during calibration
Carin A, Haudin JM, Vincent M, Monasse B, Bellet G, Amouroux N |
| 312 - 321 |
Two dimensional description of pressure-throughput behaviour of Newtonian materials considering wall slippage effects
Potente H, Kurte-Jardin M, Klus S, Timmermann K |
| 322 - 331 |
Experimental studies and modeling of development of dispersion and fiber damage in continuous compounding
Shon K, Liu D, White JL |
