| 270 - 289 |
Influence of Carbon Fillers on Thermal Properties and Flammability of Polymeric Nanocomposites
Rybinski P |
| 290 - 297 |
Polymer Flow Behavior Analysis Based on Physical Visualization Technology for Ultrasonic Vibration-Assisted Injection Molding
Jiang KY, Ji Z, Li H, Wang MJ, Yu TM |
| 298 - 307 |
Flexural Fatigue Performance of Glass Fiber/Epoxy Step-Wise Functionally and Non-Functionally Graded Composites of Different Structures
Selmy AI, Abd El-baky MA, Ghazy MR, Kamel M |
| 308 - 315 |
Establishment and Effect of Constraint on Different Mechanical Properties of Bamboo Filler Reinforced Epoxy Composite
Kumar R, Bhowmik S, Kumar K |
| 316 - 325 |
Experimental Investigation on Mechanical and Thermo-Mechanical Properties of Alumina Filled Polypropylene Composites Using Injection Molding Process
Kumar D, Dangayach GS, Rao PN |
| 326 - 336 |
Development and Characterization of Polyurethane and Acrylonitrile Butadiene Styrene and their Compatibilized Blends
Alfadhel KA, Al-Mulla A, Bishara A |
| 337 - 342 |
Mechanical Properties of Polydimethylsiloxane as a Function of the Amount and Type of Crosslinking Agent
Verheyen F, Giesen RU, Heim HP |
| 343 - 354 |
Numerical Investigation of Effect of Rotor Phase Angle in Partially-Filled Rubber Mixing
Das SR, Poudyal H, Chandy AJ |
| 355 - 362 |
Method of Calculating the Fluid Permeability of Machined Skin-Covered Porous Sheets from Experimental Flow Data
Nicolae A, Guo HM, Kumar V |
| 363 - 377 |
Analysis of Models Predicting Morphology Transitions in Reactive Twin-Screw Extrusion of Bio-Based Polyester/Polyamide Blends
Gug JI, Tan B, Soule J, Downie M, Barrington J, Sobkowicz MJ |
| 378 - 386 |
A Combined Experimental and Modelling Approach towards an Optimized Heating Strategy in Thermoforming of Thermoplastics Sheets
Buffel B, van Mieghem B, van Bael A, Desplentere F |
| 387 - 393 |
Analyzing the Influence of Surface Renewal on Diffusive Mass Transport in Vented Single-Screw Extruders
Marschik C, Low-Baselli B, Miethlinger J |
| 394 - 398 |
Research on Optimizing Parameters of Thermal Bonding Technique for PMMA Microfluidic Chip
Chen XY, Li TY, Zhang S, Yao Z, Chen XD, Zheng Y, Liu YL |
