| 470 - 477 |
Applicability of the Impact Response Analysis Method for Reinforced Concrete Beams Mixed with Polyvinyl Alcohol Short Fibers
Bhatti AQ, Kishi N, Shameem K |
| 478 - 483 |
Epoxy-Montmorillonite Nanocomposites Applied to Powder Coatings
Piazza D, Lorandi NP, Rieder ES, Scienza LC, Zattera AJ |
| 484 - 489 |
Direct Imprinting Using Magnetic Nickel Mold and Electromagnetism Assisted Pressure for Replication of Microstructures
Weng YJ |
| 490 - 497 |
Automated Mold Heating System Using High Frequency Induction with Feedback Temperature Control
Park K, Seo YS, Sohn DH |
| 498 - 507 |
The Prediction of Bowing Distortion of Film after Transverse Stretching with Consideration of Heated Air Flow in a Tenter
Tokihisa M, Kushizaki Y, Tomiyama H, Yamamoto Y, Yamada T |
| 508 - 516 |
The Influence of Injection Molding and Injection Compression Molding on Ultra-high Molecular Weight Polyethylene Polymer Microfabrication
Kuo HC, Jeng MC |
| 517 - 524 |
A Design-of-Experiment Study on the Microcellular Extrusion of Sub-critical CO2 Saturated PLA Pellets
Miller D, Kumar V |
| 525 - 539 |
Optimization of Injection Molding Process for SGF and PTFE Reinforced PC Composites Using Response Surface Methodology and Simulated Annealing Approach
Yang T, Yang YK, Chen CY |
| 540 - 550 |
Flow Visualisation in Co-rotating Twin Screw Extruders: Positron Emission Particle Tracking and Numerical Particle Trajectories
Diemer J, Chilles C, Colbert J, Miri T, Ingram A, David P, Fard AS, Anderson PD |
| 551 - 559 |
The Influence of Melt and Process Parameters on the Quality and Occurrence of Part Defects in Water-assisted Injection Molded Tubes
Sannen S, De Keyzer J, Van Puyvelde P |
| 560 - 568 |
Model and Numerical Simulation for the Second Penetration in Water-assisted Injection Molding
Zhang S, Cao W, Zheng G, Jia Z, Shen C |
| 569 - 579 |
Influence of Extrusion Conditions on the Rheological Behavior of Nuclear Bituminized Waste Products
Mouazen M, Poulesquen A, Vergnes B |
| 580 - 586 |
Influence of Dicumyl Peroxide Content on Thermal and Mechanical Properties of Polylactide
Rytlewski P, Zenkiewicz M, Malinowski R |
| 587 - 589 |
Calculation of Average Residence Time in a Ko-kneader
Vergnes B |
