| 111 - 124 |
Ultrasonic dual mode mixing and its effect on tensile properties of SiO2-epoxy nanocomposite
Halder S, Ghosh PK, Goyat MS, Ray S |
| 125 - 135 |
Adhesion degradation of rubber and steel insert for conveyor belts
Dobrota D |
| 136 - 142 |
Preparation and adhesion performance of multilayered Ni coatings deposited by ultrasonic-assisted electroplating
Yu ZM, Zhu YK, Niu YS, Yang Y, Wei J, Ding WJ |
| 143 - 153 |
Development of hot-melt pressuresensitive adhesives for transdermal drug delivery
Zhao ZF, Fang B, Li XH, Wang Q |
| 154 - 164 |
Synthesis and properties of the vinyl silicone oil modified polyacrylate core-shell latex as a binder for pigment printing
Jiang X, Hu HL, Bai YC, Tian XZ, Huang D, Wang SG |
| 165 - 181 |
Characterization and modelling of the 3D elasticplastic behaviour of an adhesively bonded joint under monotonic tension/compression-shear loads: influence of three cure cycles
Maurice J, Cognard JY, Creac'hcadec R, Davies P, Sohier L, Mahdi S |
| 182 - 195 |
Effect of pressing parameters on the shear strength of beech specimens bonded with low solvent liquefied wood
Ugovsek A, Sernek M |
| 196 - 207 |
Tribological properties of selected ceramic coatings
Vinas J, Brezinova J, Guzanova A |
| 208 - 215 |
Surface oxidation of single-walled carbon nanotube paper with oxygen atoms
Lu F, Alvarenga J, Landi B, Raffaelle R, Debies T, Takacs GA |
| 216 - 226 |
Preparation and characterization of poly (ethylene glycol) grafted Ca-alginate fibers by -irradiation for biomedical applications
Khan MK, Rahman MM, Nesa B, Nasrin R, Molla S, Islam MM, Rashid TU, Haque P, Mustafa AI, Khan MA |
