| 787 - 798 |
Some Remarks on the Removal of Adhered Particles by Oscillating Air Flows
Schlosser U, Bahners T, Schollmeyer E |
| 799 - 813 |
Influence of Erroneous Data on the Results of Calculations From Acid-Base Surface Free Energy Theories. III. Solution of a Three-Equation Set in the Case of Homoscedastic Error
Bialopiotrowicz T |
| 815 - 825 |
Influence of Erroneous Data on the Results of Calculations From Acid-Base Surface Free Energy Theories. IV. Solution of an Overdetermined Set in the Case of Homoscedastic Error
Bialopiotrowicz T |
| 827 - 837 |
Physico-chemical Causes of the Extent of Water Resistance of Linearly Welded Wood Joints
Omrani P, Pizzi A, Mansouri HR, Leban JM, Delmotte L |
| 839 - 850 |
Morphology and Properties of Waterborne Polyurethane/CNT Nanocomposite Adhesives with Various Carboxyl Acid Salt Groups
Rahman MM, Kim EY, Lim KT, Lee WK |
| 851 - 879 |
Combined Adhesion and Friction Effects on Cylinder-on-Flat Elastic-Plastic Microcontact
Sabelkin V, Mall S |
| 881 - 898 |
A Rate-Dependent Cohesive Zone Model for Adhesively Bonded Joints Loaded in Mode I
Marzi S, Hesebeck O, Brede M, Kleiner F |
| 899 - 911 |
Particle Removal in Linear Shear Flow: Model Prediction and Experimental Validation
Zoeteweij ML, van der Donck JCJ, Versluis R |
| 913 - 930 |
Enhancing the Adhesion Retention by Controlling the Structure of the Adhesion Interphase Between Rubber Compound and Metal. Part I. Effect of Cobalt Salt
Jeon GS |
