| 2791 - 2796 |
Thermoluminescence Dosimetric Properties of Beryllium-Oxide
Vij DR, Singh N |
| 2797 - 2809 |
Modeling Concurrent Deformation Mechanisms in Auxetic Microporous Polymers
Alderson A, Evans KE |
| 2811 - 2819 |
The Oxidation Behavior of Low-Temperature Heat-Treated Carbon-Fibers
Zhao LR, Jang BZ |
| 2821 - 2826 |
Overlapping Laser Tracks to Produce a Continuous Nitrided Layer in Ti-6Al-4V Alloy
Hu C, Baker TN |
| 2827 - 2833 |
Analysis of Surface Preparation Treatments for Coating Tungsten Carbide Substrates with Diamond Thin-Films
Chatterjee S, Edwards AG, Nichols A, Feigerle CS |
| 2835 - 2848 |
Processing, Microstructure and Fracture-Behavior of a Spray Atomized and Deposited Aluminum-Silicon Alloy
Anand S, Srivatsan TS, Wu Y, Lavernia EJ |
| 2849 - 2853 |
Deposition of Cnx Thin-Films by Plasma-Activated Chemical-Vapor-Deposition Using Various Precursors as Carbon Source
Gruger H, Selbmann D, Wolf E, Leonhardt A |
| 2855 - 2871 |
The Lateral Deformation of Cross-Linkable Ppxta Fibers
Jones MC, Laracurzio E, Kopper A, Martin DC |
| 2873 - 2882 |
A Comparative-Study of the Coated Filler Method and the Admixture Method of Powder-Metallurgy for Making Metal-Matrix Composites
Yih P, Chung DD |
| 2883 - 2894 |
Microstructure, Tensile Deformation and Fracture-Behavior of Aluminum-Alloy-7055
Srivatsan TS, Sriram S, Verraraghavan D, Vasudevan VK |
| 2895 - 2902 |
The Electrical and Catalytic Properties of YBa2Cu3O7-X for Oxidation Reactions Below 400 Degrees-C
Caldararu M, Ovenston A, Walls JR |
| 2903 - 2910 |
Impurity-Induced Degradation at Zirconia/Sapphire Interfaces
Stough MA, Hellmann JR, Angelone MS |
| 2911 - 2920 |
Effects of Ion-Implantation and Annealing on Mechanical-Properties of Ceramic Using Nanoindentor Techniques
Boudoukha L, Paletto S, Fantozzi G, Halitim F |
| 2921 - 2927 |
Hollow-Shell Formation - An Important Mode in the Hydration of Portland-Cement
Kjellsen KO, Lagerblad B, Jennings HM |
| 2929 - 2935 |
Polymorphism of Silica
Stevens SJ, Hand RJ, Sharp JH |
| 2937 - 2947 |
Sedimentation Behavior of Kaolinite and Montmorillonite Mixed with Iron Additives, as a Function of Their Zeta-Potential
Pierre AC |
| 2949 - 2955 |
A Sol-Gel Preparation of Silica Coated Zirconia Microspheres as Chromatographic Support Materials
Shalliker RA, Rintoul L, Douglas GK, Russell SC |
| 2957 - 2961 |
On the Mechanism of Microcrack Formation in Nanocrystalline Fe-Ni Electrodeposits
Czerwinski F, Kedzierski Z |
| 2963 - 2968 |
Wear Mechanisms of Ti(C,N) Ceramic in Sliding Contact with Stainless-Steel
Zhao XZ, Liu JJ, Zhu BL, Miao HZ, Luo ZB |
| 2969 - 2975 |
Characterization of SiC/C (B)/SiC Microcomposites by Transmission Electron-Microscopy
Jacques S, Guette A, Langlais F, Bourrat X |
| 2977 - 2984 |
Effect of Starting Particle-Size on Hot-Pressing of Magnesium-Oxide Powder Prepared by Vapor-Phase Oxidation Process
Itatani K, Yasuda R, Howell FS, Kishioka A |
| 2985 - 2989 |
The Existence of Intragranular Ferrite Plates and Nucleating Inclusions in the Heat-Affected Zone of X-60 Pipe Steel
Jian GC, Zhu YR, Guo SQ, Xu JL, Wang YQ, Pan LY, Yu DW |
| 2991 - 2996 |
Fabrication of a CuO-Infiltrated ZnO Composite and Its Gas-Sensing Properties
Uozumi G, Miyayama M, Yanagida H |
| 2997 - 3000 |
Mechanical-Properties of Rapidly Solidified Ribbons of Some Al-Si Based Alloys
Tawfik NL |
| 3001 - 3006 |
Transparent Conducting Lithium-Doped Nickel-Oxide Thin-Films by Spray-Pyrolysis Technique
Puspharajah P, Radhakrishna S, Arof AK |
| 3007 - 3011 |
Thermoelectric Properties of Mn-Doped Iron Disilicide Ceramics Fabricated from Radiofrequency Plasma-Treated Fine Powders
Tokiai T, Uesugi T, Nosaka M, Hirayama A, Ito K, Koumoto K |
| 3013 - 3019 |
The Role of Boron in Low-Temperature Synthesis of Indialite (Alpha-Mg2Al4Si5O18) by Sol-Gel Process
Sei T, Eto K, Tsuchiya T |
| 3021 - 3024 |
Pyrolysis of Glass-Hardened Polyamides Used in the Automotive Industry
Dipasquale G, Larosa AD, Recca A, Dicarlo S, Bassani MR, Facchetti S |
| 3025 - 3029 |
Lower Critical Magnetic-Field of Lithium-Containing Bi2Sr2Cacu2O8+delta Single-Crystals
Horiuchi T, Kitahama K, Kawai T |
| 3031 - 3036 |
Interaction of Si3N4 with Titanium at Elevated-Temperatures
Shimoo T, Okamura K, Adachi S |
| 3037 - 3042 |
Thin-Film and Bulk Deformation-Behavior of Poly(Ether Ether Ketone) Poly(Ether Imide) Blends
Gensler R, Plummer CJ, Kausch HH, Munstedt H |
| 3043 - 3048 |
Material Damage in-Space from Microparticle Impact
Berthoud L, Mandeville JC |
| 3049 - 3053 |
Preparation and Thermal-Decomposition of Hexa-Ammonium Tetraphosphate Dihydrate (NH4)(6)P4O13-Center-Dot-2H(2)O
Takenaka A, Fukuma Y, Yasuda A, Motooka I, Nariai H |
| 3055 - 3059 |
The Role of Cavitation and Debonding in the Toughening of Core-Shell Rubber-Modified Epoxy Systems
Lu F, Cantwell WJ, Kausch HH |
| 3061 - 3068 |
Water Binding to Biopolymers in Different Cereals and Legumes - Proton NMR Relaxation, Dielectric and Water Imbibition Studies
Ratkovic S, Pissis P |
