1143 - 1153 |
The use of new technologies in coloration of textile fibers Ahmed NSE, El-Shishtawy RM |
1154 - 1159 |
Evidence for a threshold in the biosolubility of aluminosilicate vitreous fibers Devreux F, Cailleteau C, Barboux P |
1160 - 1169 |
Structural and textural study of electrodeposited zinc from alkaline non-cyanide electrolyte Chandrasekar MS, Srinivasan S, Pushpavanam M |
1170 - 1178 |
Tailoring the tensile/compressive response of magnesium alloy ZK60A using Al2O3 nanoparticles Jayaramanavar P, Paramsothy M, Balaji A, Gupta M |
1179 - 1188 |
Ultra-long SiO2 and SiO2/TiO2 tubes embedded with Pt nanoparticles using magnus green salt as templating structures Aresipathi C, Feldhoff A, Wark M |
1189 - 1192 |
A novel method for preparation of organic resins reinforced geopolymer composites Zhang YJ, Li S, Xu DL, Wang BQ, Xu GM, Yang DF, Wang N, Liu HC, Wang YC |
1193 - 1210 |
The toughness of epoxy polymers and fibre composites modified with rubber microparticles and silica nanoparticles Hsieh TH, Kinloch AJ, Masania K, Lee JS, Taylor AC, Sprenger S |
1211 - 1219 |
Microstructural effects on the phase transitions and the thermal evolution of elastic and piezoelectric properties in highly dense, submicron-structured NaNbO3 ceramics Moure A, Hungria T, Castro A, Pardo L |
1220 - 1226 |
An etching characterization method for revealing the plastic deformation zone in a SUS303 stainless steel Okayasu M, Sato K, Takasu S |
1227 - 1230 |
A comparison of results obtained using different methods to assess the elastic properties of ceramic materials exemplified for Ba0.5Sr0.5Co0.8Fe0.2O3-delta Malzbender J, Huang B, Monch J, Steinbrech RW |
1231 - 1236 |
Heterogeneous crystallization and composition dependence of optical parameters in Sn-Sb-Bi-Se chalcogenides Ahmad M, Thangaraj R, Sathiaraj TS |
1237 - 1241 |
The room temperature photoluminescence properties of Eu3+-doped bi-phase calcium phosphate under visible light Wang H, Yu J, Li JQ, Cheng XK, Huang ZL |
1242 - 1247 |
Structural and electrical conductivity studies on undoped and copper-doped nanocrystalline zinc sulphide Chellammal S, Sankar S, Selvakumar S, Viswanathan E, Murugaraj R, Sivaji K |
1248 - 1254 |
Effect of welding heat input on microstructure and mechanical properties of simulated HAZ in Cu containing microalloyed steel Amer AE, Koo MY, Lee KH, Kim SH, Hong SH |
1255 - 1263 |
Mesoporous titania-silica composite from sodium silicate and titanium oxychloride. Part I: grafting method Hilonga A, Kim JK, Sarawade PB, Kim HT |
1264 - 1271 |
Mesoporous titania-silica composite from sodium silicate and titanium oxychloride. Part II: one-pot co-condensation method Hilonga A, Kim JK, Sarawade PB, Kim HT |
1272 - 1279 |
Electronic characterization and photocatalytic properties of TiO2/CdO electrospun nanofibers Kanjwal MA, Barakat NAM, Sheikh FA, Kim HY |
1280 - 1283 |
Mechanical studies on poly(vinyl chloride)-poly(methyl methacrylate)-based polymer electrolytes Ramesh S, Winie T, Arof AK |
1284 - 1292 |
In vitro degradation and drug release from polymer blends based on poly(dl-lactide), poly(l-lactide-glycolide) and poly(epsilon-caprolactone) McDonald PF, Lyons JG, Geever LM, Higginbotham CL |
1293 - 1298 |
Dry rolling and sliding friction and wear of organophilic layered silicate/hydrogenated nitrile rubber nanocomposite Xu D, Karger-Kocsis J |
1299 - 1306 |
Solvent control of cellulose acetate nanofibre felt structure produced by electrospinning Haas D, Heinrich S, Greil P |
1307 - 1314 |
Self-assembly of coordination polymers constructed from CuCN and unidentate pyridine bases Etaiw SEH, Amer SA, El-bendary MM |
1315 - 1320 |
Properties of polymer networks prepared by blending polyester urethane acrylate with acrylated epoxidized soybean oil Oprea S |
1321 - 1327 |
1,3,4-Oxadiazole epoxy resin-based liquid crystalline thermosets and their cure kinetics Balamurugan R, Kannan P |
1328 - 1335 |
Isothermal crystallization kinetics of poly(vinylidene fluoride) in the alpha-phase in the scope of the Avrami equation Sencadas V, Costa CM, Ribelles JLG, Lanceros-Mendez S |
1336 - 1342 |
Utilization of olive mill sludge in manufacture of lignocellulosic/polypropylene composite Ayrilmis N, Buyuksari U |
1343 - 1349 |
Functional geraniol-Ca(OH)(2) composite/sodium acetate alginate film on nonwoven polyethylene sheet: acetic acid gas production in response to acid Ichiura H, Kaneda Y, Ohtani Y |
1350 - 1353 |
Microstructures formed during devitrification of Na2O center dot Al2O3 center dot B2O3 center dot SiO2 center dot Fe2O3 glasses Harizanova R, Volksch G, Russel C |
1354 - 1360 |
High strength bio-composite films of poly(vinyl alcohol) reinforced with chemically modified-fly ash Nath DCD, Bandyopadhyay S, Yu AB, Blackburn D, White C |
1361 - 1365 |
Investigation on preparation of nano-size Gd0.2Ce0.8O2-delta material and its humidity sensing properties Hao YW, Wang J, Chen ZY |
1366 - 1370 |
The effects of temperature on the molecular orientation of zinc phthalocyanine films Gaffo L, Cordeiro MR, Freitas AR, Moreira WC, Girotto EM, Zucolotto V |
1371 - 1384 |
Study of tensile deformation behaviour of M250 grade maraging steel using acoustic emission Mukhopadhyay CK, Rajkumar KV, Jayakumar T, Raj B |
1385 - 1392 |
Improved structural stability of titanium-doped beta-Bi2O3 during visible-light-activated photocatalytic processes Wang Y, Wen YY, Ding HM, Shan YK |
1393 - 1400 |
Development of pitch-based carbon-copper composites Kumar A, Kaur M, Kumar R, Sengupta PR, Raman V, Bhatia G, Sood KN |
1401 - 1405 |
Effects of short aging on thickening anisotropy of theta' precipitate and mechanical properties of severe cold-rolled 2519A aluminum alloy plate Zhang XM, Gao ZG, Zhao YS |
1406 - 1410 |
A preliminary study of calcium containing plasma electrolytic oxidation coatings on AM50 magnesium alloy Srinivasan PB, Liang J, Blawert C, Stormer M, Dietzel W |
1411 - 1418 |
A non-destructive method for thickness measurement of thin electrospun membranes using white light profilometry Affandi NDN, Truong YB, Kyratzis IL, Padhye R, Arnold L |
1419 - 1424 |
Controlled synthesis of MnFe2O4-Ni core-shell nanoparticles Yang SC, Ahn CW, Park CS, Yang YD, Viehland D, Priya S |