| 1557 - 1567 |
Effects of injection-molding conditions on the gloss and color of pigmented polypropylene
Pisciotti F, Boldizar A, Rigdahl M, Arino I |
| 1568 - 1575 |
Properties of polypropylene/aluminum trihydroxide composites containing nanosized organoclay
Ristolainen N, Hippi U, Seppala J, Nykanen A, Ruokolainen J |
| 1576 - 1580 |
Dielectric properties of an epoxy-amine system at a high microwave frequency
Zong LM, Zhou SJ, Sgriccia N, Hawley MC, Sun RS, Kempel LC |
| 1581 - 1589 |
Cure kinetics and modeling of an epoxy resin cross-linked in the presence of two different diamine hardeners
Lahlali D, Naffakh M, Dumon M |
| 1590 - 1599 |
Minimum wet thickness for double-layer slide-slot coating of poly(vinyl-alcohol) solutions
Lin YN, Liu TJ, Hwang SJ |
| 1600 - 1605 |
New description of viscoelasticity that can be applied to mechanical properties such as constant strain rate, creep, and stress relaxation analysis
Sudduth RD |
| 1606 - 1614 |
Weld lines in nylon 6 melt-blended nanocomposites
Tung J, Simon GP, Edward GH |
| 1615 - 1621 |
Fabrication and characterization of biodegradable poly(lactic acid)/layered silicate nanocomposites
Wu TM, Chiang MF |
| 1622 - 1629 |
Hydrocarbon stability of perfluorinated polyether rubbers at elevated temperatures
Bigg DM, Heater KJ, Skidmore TL, Arai M |
| 1630 - 1638 |
The effect of the volume fraction of dispersed phase on toughness of injection molded polypropylene blended with SEBS, SEPS, and SEP
Matsuda Y, Hara M, Mano T, Okamoto K, Ishikawa M |
| 1639 - 1644 |
Effect of CO2 sorption and desorption on the creep response of polycarbonate arun pasricha
Pasricha A, Wing G, Kumar O, Tuttle M, Seeler K |
| 1645 - 1654 |
Morphology, viscoelastic properties, and mechanical behavior of epoxy resin modified with hydroxyl-terminated poly(ether ether ketone) oligomer with pendent tert-butyl groups
Francis B, Rao VL, Ramaswamy R, Jose S, Thomas S, Raju KVSN |
| 1655 - 1665 |
Injection molding-induced morphology of thermoplastic polymer blends
Zhong GJ, Li ZM |
| 1666 - 1672 |
Ultrasonic improvement of weld line strength of injection-molded polystyrene and polystyrene/polyethylene blend parts
Lu C, Yu XF, Guo SY |
| 1673 - 1679 |
Investigation of odd-odd nylons based on undecanedioic acid. 2: Crystal structures
Cui XW, Li WH, Yan DY |
