| 211 - 235 |
A continuous test data method to determine a reference curve and shift rate for isothermal physical aging
Bradshaw RD, Brinson LC |
| 236 - 248 |
Experimental study of post-shear crystallization of polypropylene melts
Lee O, Kamal MR |
| 249 - 260 |
Effects of solvent-particle interaction kinetics on microstructure formation during three-dimensional printing
Wu BM, Cima MJ |
| 261 - 267 |
Relationship between surface potential and second harmonic generation in chromophore-doped poly(ethylene oxide)/atactic-poly(methyl methacrylate) blends
Vannikov AV, Vernel J, Mal'tsev EI, Savel'ev VV, Rychwalski RW |
| 268 - 273 |
Environmental stress cracking of poly(acrylonitrile-butadiene-styrene)
Kawaguchi T, Nishimura H, Miwa F, Abe K, Kuriyama T, Narisawa I |
| 274 - 285 |
Effect of filler on cure behavior of an epoxy system: Cure modeling
Lu MG, Shim M, Kim S |
| 286 - 298 |
A new approach to analyzing residence time and mixing in a co-rotating twin screw extruder
Gasner GE, Bigio D, Marks C, Magnus F, Kiehl C |
| 299 - 311 |
Preparation of macromolecular tracers and their use for studying the residence time distribution of polymeric systems
Hu GH, Kadri I |
| 312 - 320 |
Effect of compatibilizers on mechanical properties and morphology of in-situ composite film of thermotropic liquid crystalline polymer/polypropylene
Bualek-Limcharoen S, Samran J, Amornsakchai T, Meesiri W |
| 321 - 326 |
The adhesion between electrolessly deposited copper and a photoimageable polymer
Suzuki M, Kawamoto M, Takahashi A |
| 327 - 339 |
Extrusion characteristics of thermoplastic melts containing fluoropolymers
Lee E, White JL |
| 340 - 346 |
Long fiber reinforcement of polypropylene/polystyrene blends
Inberg JPF, Hunse PH, Gaymans RJ |
| 347 - 355 |
In-line residence time distribution of dicarboxylic acid oligomers/dioxazoline chain extension by reactive extrusion
Chalamet Y, Taha M |
| 356 - 364 |
Essential fracture work of short fiber reinforced polymer blends
Wong SC, Mai YW |
| 365 - 374 |
Polymer blends with spatially graded structures prepared by phase separation under a temperature gradient
Tran-Cong Q, Okinaka J |
| 375 - 384 |
Optimized runner systems for multicavity injection molds. Part I: Runner sizing
Lee CC, Stevenson JF |
| 385 - 392 |
Brittle to ductile: Fracture toughness mapping on controlled epoxy networks
Crawford ED, Lesser AJ |
