Polymer Engineering and Science

Polymer Engineering and Science, Vol.45, No.4 Entire volume, number list

ISSN: 0032-3888 (Print)

In this Issue (20 articles)

443 - 450	Experimental studies on the development of a cast film Seyfzadeh B, Harrison GM, Carlson CD
451 - 457	Intercalation and exfoliation of talc by solid-state shear compounding ((SC)-C-3) using Pan-Mill equipment Shao WG, Wang Q, Li KS
458 - 468	Oriented crystallization and mechanical properties of polypropylene nucleated on fibrillated polytetrafluoroethylene scaffolds van der Meer DW, Milazzo D, Sanguineti A, Vancso GJ
469 - 477	Morphology and properties of layered silicate-polyethylene nanocomposite blown films Zhong Y, De Kee D
478 - 486	Curing and pyrolysis of cresol novolac epoxy resins containing BABODOPN Rwei SP, Cheng CY, Liou GS, Cheng KC
487 - 495	Fracture toughness and impact strength of anhydride-cured biobased epoxy Miyagawa H, Misra M, Drzal LT, Mohanty AK
496 - 509	Kinetic analysis and mechanical properties of nanoclay reinforced unsaturated polyester (UP) resins cured at low temperatures Xu LQ, Lee LJ
510 - 516	Fatigue performance of an injection molded talc-filled polypropylene Zhou YX, Mallick PK
517 - 528	Auxetic polypropylene films Ravirala N, Alderson A, Alderson KL, Davies PJ
529 - 538	Irradiation-induced surface graft polymerization onto calcium carbonate nanoparticles and its toughening effects on polypropylene composites Ma CG, Rong MZ, Zhang MQ, Friedrich K
539 - 548	Dynamic properties of rubber vibration isolators and antivibration performance blends system of nanoclay-modified PU/PEL blends system Chiu HT, Wu JH, Shong ZJ
549 - 559	Rheology of wood plastics melt. Part 1. Capillary rheometry of HDPE filled with maple Li TQ, Wolcott MP
560 - 567	Rheokinetics of the cross-linking of melt polyethylene initiated by peroxide Liu MG, Zhou CX, Yu W
568 - 578	Novel fabrication route for auxetic polyethylene. Part 1. Processing and microstructure Alderson KL, Webber RS, Kettle AP, Evans KE
579 - 587	Photo-induced scission and crosslinking in LDPE, LLDPE, and HDPE Craig IH, White JR, Shyichuk AV, Syrotynska I
588 - 595	Crystallization and chemi-crystallization of recycled photodegraded polyethylenes Craig IH, White JR
596 - 605	Orientation and strain cycle effects on the impact performance of polyethylene Paizis A, Leevers P
606 - 612	Real-time monitoring of in microfluidic devices using jection molding for ultrasound Ono Y, Jen CK, Cheng CC, Kobayashi M
613 - 621	Injection molding of long sisal fiber-reinforced polypropylene: Effects of compatibilizer concentration and viscosity on fiber adhesion and thermal degradation Arzondo LM, Perez CJ, Carella JM
622 - 629	Melt-stable poly(1,4-dioxan-2-one) (Co)polymers by ring-opening polymerization via continuous reactive extrusion Raquez JM, Degee P, Dubois P, Balakrishnan S, Narayan R