| 593 - 609 |
Chemorheology of Thermosets - An Overview
Halley PJ, Mackay ME |
| 610 - 614 |
The Effect of Cure Cycle of Unsaturated Polyester Resin on the Temperature and Conversion Profiles
Alperstein D, Narkis M, Siegmann A |
| 615 - 625 |
Mechanical-Properties of Rotationally Molded Nyrim
Harkinjones E, Crawford RJ |
| 626 - 635 |
A New Design Procedure for Profile Extrusion Dies
Hurez P, Tanguy PA, Blouin D |
| 636 - 642 |
The Effects of Powder Morphology on the Processing of Auxetic Polypropylene (pp of Negative Poissons Ratio)
Pickles AP, Alderson KL, Evans KE |
| 643 - 650 |
Non-Newtonian Flow Modeling in the Mixing Section of a Single-Screw Extruder with Flow-Analysis Network Method
Wang Y, Tsay CC |
| 651 - 657 |
Generation of Large Residual-Stresses in Injection Moldings
Kwok CS, Tong L, White JR |
| 658 - 675 |
Solidification of Thermoviscoelastic Melts .4. Effects of Boundary-Conditions on Shrinkage and Residual-Stresses
Bushko WC, Stokes VK |
| 676 - 684 |
Devolatilization - A Critical Sequential Operation for in-Situ Compatibilization of Immiscible Polymer Blends by One-Step Reactive Extrusion
Hu GH, Sun YJ, Lambla M |
| 685 - 702 |
Photothermal Imaging of Dehydrochlorination in Poly(Vinyl Chloride) Films
Prystay MC, Power JF |
| 703 - 712 |
Bulk Crystallization of Poly(Aryl Ether Ether Ketone) (Peek)
Medellin-Rodriguez FJ, Phillips PJ |
| 713 - 720 |
Liquid-Crystalline Polymer Blends with Stabilized Viscosity
Wei KH, Kiss G |
| 721 - 730 |
Competition Between Textural Transitions and Pressure Effects on the Viscosity of Thermotropic Liquid-Crystal Polymers
Izu P, Munoz ME, Pena JJ, Santamaria A |
| 731 - 736 |
A Temperature Rising Elution Fractionation Study of Short-Chain Branching Behavior in Ultra-Low Density Polyethylene
Karoglanian SA, Harrison IR |
