Polymer Engineering and Science

Polymer Engineering and Science, Vol.45, No.7 Entire volume, number list

ISSN: 0032-3888 (Print)

In this Issue (15 articles)

889 - 897	Morphological influence on mechanical characterization of ethylene-vinyl acetate copolymer-clay nanocomposites Chaudhary DS, Prasad R, Gupta RK, Bhattacharya SN
898 - 903	Effect of diatomite/polyethylene glycol binary processing aid on the melt fracture and the rheology of polyethylenes Liu XL, Li HL
904 - 914	CO2 sorption and diffusion in polymethyl methacrylate-clay nanocomposites Manninen AR, Naguib HE, Nawaby AV, Day M
915 - 925	Hot embossing precise structure onto plastic plates by ultrasonic vibration Liu SJ, Dung YT
926 - 934	Study of mixing of liquid/polymer in twin screw extruder by residence time distribution Cassagnau P, Courmont M, Melis F, Puaux JP
935 - 944	Fatigue strength of vibration-welded unreinforced nylon butt joints Tsang KY, DuQuesnay DL, Bates PJ
945 - 952	Experimental and numerical investigation of warpage of semicrystalline polymers in rotational molding Glomsaker T, Larsen A, Andreassen E, Ommundsen E
953 - 965	Optimization-based design of polymer sheeting dies using generalized Newtonian fluid models Smith DE, Wang Q
966 - 975	Comparison of the performance of vulcanized rubbers and elastomer/TPE/iron composites for less lethal ammunition applications Puskas JE, Kumar B, Ebied A, Lamperd B, Kaszas G, Sandler J, Altstadt V
976 - 983	Use of preimpregnated sisal yarn in women reinforced polypropylene sheets: Thermoformability and mechanical properties Arzondo LM, Perez CJ
984 - 997	Influence of long-chain branching on the rheological behavior of polyethylene in shear and extensional flow Barroso VC, Maia JM
998 - 1010	In-line monitoring and analysis of polymer melting behavior in an intermeshing counter-rotating twin-screw extruder by ultrasound waves Wang DB, Min K
1011 - 1020	Color mixing in the metering zone of a single screw extruder: Numerical simulations and experimental validation Alemaskin K, Manas-Zloczower I, Kaufman M
1021 - 1030	Effects of geometry and injection-molding parameters on weld-line strength Wu CH, Liang WJ
1031 - 1038	Entropic analysis of color homogeneity Alemaskin K, Manas-Zloczower I