| 1 - 12 |
Enhanced C3H6/C3H8 separation performance in poly(vinyl acetate) membrane blended with ZIF-8 nanocrystals
Yu J, Wang CQ, Xiang L, Xu YZ, Pan YC |
| 13 - 31 |
Optimal design of hybrid cryogenic flash and membrane system
Liao ZW, Hu YX, Tu GN, Sun JY, Jiang BB, Wang JD, Yang YR |
| 32 - 52 |
Coupled CFD-DEM simulation of oscillatory particle-laden fluid flow through a porous metal foam heat exchanger: Mitigation of particulate fouling
Kuruneru STW, Sauret E, Saha SC, Gu YT |
| 53 - 63 |
Assessment of different coarse graining strategies to simulate polydisperse gas-solids flow
Lu LQ, Xu YP, Li TW, Benyahia S |
| 64 - 72 |
Modeling of CO2 diffusion into water-shielded oil at pore scale using oving mesh technique
Fayazi A, Kantzas A |
| 73 - 82 |
Emulsion behavior control and stability study through decorating silica nano-particle with dimethyldodecylamine oxide at n-heptane/water interface
Dai CL, Li H, Zhao MW, Wu YN, You Q, Sun YP, Zhao G, Xu K |
| 83 - 91 |
Impact of cellulose treatment with hydrotalcites in hydrothermal catalytic conversion
Guarin C, Gavila L, Constanti M, Medina F |
| 92 - 103 |
Chemical-looping water splitting over ceria-modified iron oxide: Performance evolution and element migration during redox cycling
Zhu X, Zhang MY, Li KZ, Wei YG, Zheng Y, Hu JH, Wang H |
| 104 - 114 |
Effects of obstacle lengths on the asymmetric breakup of a droplet in a straight microchannel
Ma YL, Zheng MM, Bah MG, Wang JT |
| 115 - 132 |
Color-PTV measurement and CFD-DEM simulation of the dynamics of poly-disperse particle systems in a pseudo-2D fluidized bed
Jiang ZC, Hagemeier T, Buck A, Tsotsas E |
| 133 - 149 |
Computational fluid dynamic studies of mixers for highly viscous shear thinning fluids and PIV validation
Cortada-Garcia M, Weheliye WH, Dore V, Mazzei L, Angeli P |
| 150 - 160 |
A new approach of studying mixed gas hydrates involving propane at non-equilibrium conditions and final state: An experimental study and modeling
Babakhani SM, Bouillot B, Douzet J, Ho-Van S, Herri JM |
| 161 - 171 |
Analysis of the dynamic characteristics of air-water two-phase flow in small channel based on multi-scale normalized Benford probability distribution
Li HW, Pei HF, Yang D, Sun D, Zhou YL |
| 172 - 184 |
Effects of surface-active agents on bubble growth and detachment from submerged orifice
Babu R, Das MK |
| 185 - 197 |
Observer-based extended generic model control of a reactive batch distillation
Banerjee S, Jana AK |
| 198 - 213 |
An agglomerate model for PEM fuel cells operated with non-precious carbon-based ORR catalysts
Xing L |
| 214 - 220 |
Development of a diffusion-limited shrinking particle model of cellulose dissolution in a carbon dioxide switchable system
Nanta P, Skolpap W, Kasemwong K, Shimoyama Y |
| 221 - 226 |
The role of initial geometry in experimental models of wound closing
Jin W, Lo KY, Chou SE, Mccue SW, Simpson MJ |
| 227 - 242 |
Mechanistic and constrained thermochemical modelling in chemical reactor engineering: Ti(IV) chloride oxidation revisited
Koukkari P, Paiva E |
| 243 - 256 |
An improved meso-scale flow model of gas-liquid-solid fluidized beds
Ma YL, Liu MY, Zhang Y |
| 257 - 264 |
Deposition of polymer films by spin casting: A quantitative analysis
Danglad-Flores J, Eickelmann S, Riegler H |
| 265 - 283 |
A study on the influence of the tube layout on sub-channel hydrodynamics in a bubble column with internals
Moller F, Lau YM, Seiler T, Hampel U, Schubert M |
| 284 - 295 |
Dynamic process behavior and model validation of reactive dividing wall columns
Egger T, Fieg G |
