| 219 - 227 |
Investigating the flow characteristics of air-lift pumps operating in gas-liquid two-phase flow
Wang ZN, Kang Y, Wang XC, Li D, Hu D |
| 228 - 237 |
A CFD model for predicting the heat transfer in the industrial scale packed bed
Hou BL, Ye RM, Huang YQ, Wang XD, Zhang T |
| 238 - 244 |
Modulating the mean residence time difference of wide-size particles in a fluidized bed
Zhao H, Li J, Zhu QS, Li HZ |
| 245 - 251 |
Effect of the operation parameters on the Fischer-Tropsch synthesis in fluidized bed reactors
Zhang XL, Qian WX, Zhang HT, Sun QW, Ying WY |
| 252 - 258 |
Dissolution of antibiotics mycelium in ionic liquids: Performance and mechanism
Yang JR, Li WL, Liu QF, Liu HZ |
| 259 - 267 |
Protein adsorption onto diethylaminoethyl dextran modified anion exchanger: Effect of ionic strength and column behavior
Bai S, Gong LL, Han DT, Li YT, Yu LL, Sun Y |
| 268 - 277 |
Insight into fouling behavior of poly(vinylidene fluoride) (PVDF) hollow fiber membranes caused by dextran with different pore size distributions
Zeng KL, Zhou J, Cui ZL, Zhou Y, Shi C, Wang XZ, Zhou LY, Ding XB, Wang ZH, Drioli E |
| 278 - 292 |
Transport hindrances with electrodialytic recovery of citric acid from solution of strong electrolytes
Chandra A, Tadimeti JGD, Chattopadhyay S |
| 293 - 302 |
Carbon dioxide induced degradation of diethanolamine during absorption and desorption processes
Islam MS, Dhanavath KN, Kao N, Bhattacharjee PK, Ali BS, Yusoff R |
| 303 - 316 |
Impacts of different drying strategies on drying characteristics, the retention of bio-active ingredient and colour changes of dried Roselle
Tham TC, Ng MX, Gan SH, Chua LS, Aziz R, Abdullah LC, Ong SP, Chin NL, Law CL |
| 317 - 321 |
Solvent extraction kinetics of Sm(III), Eu(III) and Gd(III) with 2-ethylhexyl phosphoric acid-2-ethylhexyl ester
Chen Z, Wang YD |
| 322 - 329 |
Ni nanoparticles supported on carbon as efficient catalysts for steam reforming of toluene (model tar)
Shen C, Zhou WQ, Yu H, Du L |
| 330 - 336 |
Preparation and characterization of H4SiW12O40@MIL-100(Fe) and its catalytic performance for synthesis of 4,4 '-MDA
Kong YH, Cheng XM, An HL, Zhao XQ, Wang YJ |
| 337 - 342 |
A new nanocluster polyoxomolybdate [Mo36O110(NO)(4)(H2O)(14)]center dot 52H(2)O: Synthesis, characterization and application in oxidative degradation of common organic dyes
Amini M, Khaksar M, Ellern A, Woo LK |
| 343 - 355 |
Kinetic studies on extra heavy crude oil upgrading using nanocatalysts by applying CFD techniques
Dehkordi JA, Jafari A, Sabet SA, Karami F |
| 356 - 363 |
Gas emission source term estimation with 1-step nonlinear partial swarm optimization-Tikhonov regularization hybrid method
Ma DL, Tan W, Zhang ZX, Hu J |
| 364 - 372 |
Surface chemical characterization of deactivated low-level mercury catalysts for acetylene hydrochlorination
Liu C, Liu CH, Peng JH, Zhang LB, Wang SX, Ma AY |
| 373 - 379 |
Experimental investigation on CO2-light crude oil interfacial and swelling behavior
Lashkarbolooki M, Ayatollahi S |
| 380 - 385 |
Biosynthesis of 4-hydroxyphenylpyruvic acid from L-tyrosine using recombinant Escherichia coli cells expressing membrane bound L-amino acid deaminase
Ding HR, Zhao WR, Lu CJ, Huang J, Hu S, Yao SJ, Mei LH, Wang JB, Mei JQ |
| 386 - 392 |
Process development for producing a food-grade glucose solution from rice straws
Wang CH, Chen WH, Liu HS, Lai JT, Hsu CC, Wan BZ |
| 393 - 399 |
Biodegradation of natural and synthetic estrogens in moving bed bioreactor
Amin MM, Bina B, Ebrahim K, Yavari Z, Mohammadi F |
| 400 - 406 |
Molten waste plastic pyrolysis in a vertical falling film reactor and the influence of temperature on the pyrolysis products
Jin ZC, Chen DZ, Yin LJ, Hu YY, Zhu HQ, Hong L |
| 407 - 414 |
Characteristics of oil shale pyrolysis in a two-stage fluidized bed
Tian Y, Li MY, Lai DG, Chen ZH, Gao SQ, Xu GW |
| 415 - 420 |
Carbon foams prepared from coal tar pitch for building thermal insulation material with low cost
Liu X, Wang YL, Zhan L |
| 421 - 427 |
Electrodeposition and characterization of Cu2O thin films using sodium thiosulfate as an additive for photovoltaic solar cells
Rahal H, Kihal R, Affoune AM, Rahal S |
| 428 - 435 |
Comparison of the effect of carbon, halloysite and titania nanotubes on the mechanical and thermal properties of LDPE based nanocomposite films
Majeed K, AlMaadeed MA, Zagho MM |
