| 783 - 789 |
Characterization of eluent by hot water extraction of coals in terms of total organic carbon and environmental impacts
Nakajima T, Kanda T, Fukuda T, Takanashi H, Ohki A |
| 791 - 800 |
Oxygenate kinetics in Fischer-Tropsch synthesis over an industrial Fe-Mn catalyst
Teng BT, Zhang CH, Yang J, Cao DB, Chang J, Xiang HW, Li YW |
| 801 - 808 |
The effects of dispersants (PSS-NSF) used in coal-water slurries on the grindability of coals of different structures
Atesok G, Dincer H, Ozer M, Mutevellioglu A |
| 809 - 815 |
Low-temperature pyrolysis of sewage sludge and putrescible garbage for fuel oil production
Shen L, Zhang DK |
| 817 - 824 |
Tar reduction through partial combustion of fuel gas
Houben MP, de Lange HC, van Steenhoven AA |
| 825 - 831 |
Investigation of bubble-point vapor pressures for mixtures of an endothermic hydrocarbon fuel with ethanol
Sun HY, Fang WJ, Guo YS, Lin RS |
| 833 - 840 |
Comparisons of pulverized coal combustion in air and in mixtures of O-2/CO2
Liu H, Zailani R, Gibbs BM |
| 841 - 848 |
Behaviour of gaseous chlorine and alkali metals during biomass thermal utilisation
Wei XL, Schnell U, Hein KRG |
| 849 - 857 |
Predicting the heating value of sewage sludges in Thailand from proximate and ultimate analyses
Thipkhunthod P, Meeyoo V, Rangsunvigit P, Kitiyanan B, Siemanond K, Rirksomboon T |
| 859 - 867 |
Characterisation of very high pressure diesel sprays using digital imaging techniques
Delacourt E, Desmet B, Besson B |
| 869 - 874 |
Optimising H-2 production from model biogas via combined steam reforming and CO shift reactions
Effendi A, Hellgardt K, Zhang ZG, Yoshida T |
| 875 - 884 |
Comparative studies of oil compositions produced from sawdust, rice husk, lignin and cellulose by hydrothermal treatment
Karagoz S, Bhaskar T, Muto A, Sakata Y |
| 885 - 892 |
On the intrinsic reaction rate of biomass char gasification with carbon dioxide and steam
Klose W, Wolki M |
| 893 - 901 |
Desulfurization of coke by recycling COG in coking process
Guo ZC, Tang HQ, Liu JL |
| 903 - 910 |
Two-step adsorption process for deep desulfurization of diesel oil
Sano Y, Sugahara K, Choi KH, Korai Y, Mochida I |
| 911 - 916 |
Adsorption of Hg and NOX on coal by-products
Rubel A, Andrews R, Gonzalez R, Groppo J, Robl T |
| 917 - 926 |
Water gas shift reaction kinetics in Fischer-Tropsch synthesis over an industrial Fe-Mn catalyst
Teng BT, Chang J, Yang J, Wang G, Zhang CH, Xu YY, Xiang HW, Li YW |
| 927 - 937 |
Investigations on fouling rate in convective bundles of coal-fired boilers in relation to optimization of sootblower operation
Kalisz S, Pronobis M |
| 939 - 941 |
Effect of coal extracted with NMP on its aggregation
Shui HF |
| 943 - 950 |
Vapor pressure and normal boiling point predictions for pure methyl esters and biodiesel fuels
Yuan W, Hansen AC, Zhang Q |
| 951 - 959 |
Effect of additives on the antiknock properties and Reid vapor pressure of gasoline
da Silva R, Cataluna R, de Menezes EW, Samios D, Piatnicki CMS |
| 961 - 971 |
Effect of engine parameters and gaseous fuel type on the cyclic variability of dual fuel engines
Selim MYE |
| 973 - 991 |
Phase-mineral and chemical composition of coal fly ashes as a basis for their multicomponent utilization. 4. Characterization of heavy concentrates and improved fly ash residues
Vassilev SV, Menendez R |
| 993 - 1006 |
Comparison of nickel- and iron-based oxygen carriers in chemical looping combustion for CO2 capture in power generation
Wolf J, Anheden M, Yan JY |
| 1007 - 1010 |
A correlation between stoichiometrical ratio of fuel and its higher heating value
Zhu XF, Venderbosch R |
| 1011 - 1018 |
Characterization of light duty Diesel engine pollutant emissions using water-emulsified fuel
Armas O, Ballesteros R, Martos FJ, Agudelo JR |
| 1019 - 1021 |
Combination of thermochemical recuperative coal gasification cycle and fuel cell for power generation
Kuchonthara P, Bhattacharya S, Tsutsumi A |
| 1023 - 1026 |
The conglomerating characteristics of asphaltenes from residue during thermal reaction
Zhang LL, Yang GH, Que GH |
