Bacterial adhesion in relation to urinary-tract infections has gained importance in the last years because of the increasing catheterization in hospitals to assist post-surgery flow of urine. Since the initial adhesion of bacteria to biomaterials is governed by physicochemical forces emerging from the physicochemical properties of both interacting phases, we have investigated the physicochemical surface changes of uropathogen Enterococcus faecalis ATCC29212 bacteria due to the presence of urine in its growth medium and to the differences in the environmental temperature. Urine-grown cells were found to be less hydrophobic based on water contact angles at 22degreesC, while no changes were detected at 37degreesC. In addition, they exhibited higher acid-base surface energy component than urine-free cultured cells. These changes in surface properties were also reflected in thermodynamic predictions of the adhesion to glass and silicone, which were experimentally compared with the in vitro adhesion curves obtained in a parallel plate flow chamber. The shapes of the adhesion graphs indicated that interaction free energies should be used to describe only the initial adhesion stages. Adhesion to silicone was always enhanced by urine-grown cells, while the adhesion to glass did not seem to be affected by the urine constituents. Despite the fact that the interaction free energies were not able to explain the adhesion process in some cases, changes in the electron-donor and electron-acceptor parameters of their surface free energy due to urine addition seemed to have a relation with initial adhesion rates.