Reactive radio frequency magnetron sputter-deposited chromium oxide coatings were annealed at different temperatures and times. The influence of annealing temperature on the microstructure, surface morphology and mechanical properties was examined by X-ray diffraction, nanoindentation, pin-on-disc wear and scratch tests, respectively. X-ray results show that the chromium oxide sputtered at room temperature in low oxygen flux is primarily amorphous. Annealing below 400 degrees C did not cause much change, while annealing at higher temperature of 500 degrees C caused a significant change in microstructure and mechanical properties. Hardness increased from 12.3 GPa to 26 GPa, and the wearability improved with higher annealing temperature due to the formation of crystalline Cr2O3 phase, which occurs at 470 degrees C. Annealing time had little effect on mechanical properties and microstructure, although coating surface roughness increased with a longer annealing time. Coating adhesion was improved by annealing, due to residual stress relief and possible interfacial interdiffusion. (C) 2007 Elsevier B.V. All rights reserved.