Thin Solid Films, Vol.517, No.11, 3265-3268, 2009
Effects of substrate on the structural, electrical and optical properties of Al-doped ZnO films prepared by radio frequency magnetron sputtering
Transparent and conductive Al-doped ZnO (AZO) thin films were deposited on substrates including alkali-free glass, quartz glass, Si, and SiO(2) buffer layer on alkali-free glass by using radio frequency magnetron sputtering. The effects of different substrates on the structural, electrical and optical properties of the AZO films were investigated. It was found that the crystal structures were remarkably influenced by the type of the substrates due to their different thermal expansion coefficients, lattice mismatch and flatness. The AZO film (100 nm in thickness) deposited on the quartz glass exhibited the best crystallinity, followed sequentially by those deposited on the Si, the SiO(2) buffer layer, and the alkali-free glass. The film deposited on the quartz glass showed the lowest resistivity of 5.14x10(-4) Omega cm among all the films, a carrier concentration of 1.97x10(21) cm(-3) and a Hall mobility of 6.14 cm(2)/v.s. The average transmittance of this film was above 90% in the visible light spectrum range. Investigation into the thickness-dependence of the AZO films revealed that the crystallinity was improved with increasing thickness and decreasing surface roughness, accompanied with a decrease in the film resistivity. (C) 2008 Elsevier B.V. All rights reserved.
Keywords:Al-doped zinc oxide;Radio-frequency magnetron sputtering;Substrates selection;Thickness;X-ray diffraction;Electrical properties and measurements;Transmittance