The tubular membrane filtration system is widely applied to solid-liquid separation processes. Any improvements to the filtration module would increase separation efficiency, thus reducing operating costs. In this experiment, PMMA powder with an average particle diameter of 0.8 mu m was filtered by a ceramic tubular membrane with an average pore size of 0.2 mu m, and the impacts of the operating variables, such as suspension concentration, the filtration pressure, and the crossflow velocity on the permeate flux were discussed. In order to understand the increased permeate flux, the proposed module is comparable to the tubular membrane filtration module, but with an additional side stream under the same filtration mass flow rate. In addition, variations of shear force on the membrane surface are analyzed by CFD simulation, and the influence of backwash operations on the permeate flux is discussed. The results show that the side stream membrane filtration increased the shear force on the membrane surface, reduced fouling on the membrane surface, and increased the permeate flux. Furthermore, a backwash operation with a side stream flow channel could effectively clean the particles deposited in the module, thus, increasing the permeate flux.