This paper reports measurements made for DIPPR Research Project 821 in the 1993 Project Year. Vapor pressures were measured to a pressure limit of 270 kPa or lower decomposition point for all seven compounds using a twin ebulliometric system and, for dimethyl isophthalate and N,N’-bis(2-hydroxyethyl)-ethylenediamine, additionally an inclined-piston apparatus. Liquid-phase densities along the saturation line were measured for each compound over a range of temperature (ambient to a maximum of 548 K). A differential scanning calorimeter (DSC) was used to measure two-phase !liquid + vapor) heat capacities for each compound in the temperature region ambient to the critical temperature or lower decomposition point. Where possible, the critical temperature and critical density for each compound were determined experimentally. The results of the measurements were combined to derive a series of thermophysical properties including critical temperature, critical density, critical pressure, acentric factor, enthalpies of vaporization (restricted to within +/-50 K of the temperature region of the experimentally determined vapor pressures), enthalpies of fusion if solid at ambient temperature, solubility parameter, and heat capacities along the saturation line. Wagner-type vapor-pressure equations were derived for each compound. In addition, the liquid-phase densities were compared with values derived using a three-term [(1 -T-r)(1/3)] power series. All measured and derived values were compared with those obtained in a search of the literature. Recommended critical parameters are listed for each of the compounds studied. A "Rule-Of-Thumb" derived in the 1992 Project Year is used to estimate thermal decomposition temperatures by radical scission from a knowledge of the bond dissociation energy or vice versa.