화학공학소재연구정보센터
Langmuir, Vol.29, No.31, 9841-9848, 2013
Effect of Oil Droplets and Their Solid/Liquid Composition on the Phase Separation of Protein-Polysaccharide Mixtures
The phase separation of a model system consisting of sodium caseinate + xanthan +/- a low fraction (up to 3 wt %) of an oil-in-water emulsion was studied at room temperature (20-25 degrees C). The composition of the oil phase was either 100 wt % n-tetradecane (TD); 50% TD + 50% eicosane (EC) or 100% EC. The droplets in these three "emulsions" were therefore totally liquid, partially solid, and totally solid, respectively. In the presence of 22 mM CaCl2, the mixed TD+EC droplets were most effective at inhibiting phase separation, while the EC emulsions could not prevent phase separation at all. At 32 mM CaCl2 the emulsions tended to promote phase separation, possibly due to enhanced calcium ion-induced droplet aggregation. The apparent interfacial viscosity (eta(i)) between two macroscopically separated phases was also measured. In the presence of the semisolid mixed droplets eta(i) = 25 mN s m(-1), significantly higher than eta(i) with the pure (liquid) TD droplets (15 mN s m(-1)) or with the pure solid EC droplets (12 mN s m(-1)) or in the absence of droplets (<3 mN s m(-1)). Confocal microscopy showed that the microstructure of the phase separating regions also depended upon the composition of the oil droplets, and it is tentatively suggested that the more marked effects of the mixed emulsion droplets were due to them forming a stronger network at the interface via partial coalescence. Control of the extent of interfacial aggregation of droplets is therefore possibly one way to influence the course of phase separation in biopolymer mixtures.