Double Cantilever Beam (DCB) specimens were made from aluminium plates bonded with Hysol (R) EA9321 epoxy adhesive. These were tested both under monotonic and cyclic loading conditions. Experimental testing data were obtained from classic force and displacement measurements, as well as from backface strain recordings. Apart from the usual crack propagation monitoring, evolution of the process zone at the crack tip was studied during the experiment. Results of fatigue were compared with those of standard loading. Despite the viscoelastic nature of the adhesive, an elastic treatment of the results proved most satisfactory. In addition, good agreement was found between experimental and theoretical results obtained with a Timoshenko beam on Winkler elastic foundation model.