In this study, two commercial sacrificial anti-graffiti systems, provided as water emulsion, were applied on a highly porous stone. The behavior of the anti-graffiti treatments was investigated by means of differential scanning calorimetry (DSC), Fourier transform infrared spectroscopy in attenuated total reflectance mode (ATR-FTIR), colorimetric tests, and water static contact angle measurements. The presence of a protective coating enhanced the removal of paint sprayed on the stone. However, penetration of the staining agent below the surface, due to the high porosity of the substrate, caused difficulties in eliminating the paint. In fact, repeated cleaning procedures, involving hot water, mechanical action, and chemical removers, did not allow a complete removal of the paint. The examined systems behaved against graffiti in different ways. No affinity between the wax-based product and the paint was observed; nevertheless, this behavior did not result in good anti-graffiti performances. On the contrary, the penetration of the paint into the fluorine-based coating yielded a good anti-graffiti effectiveness, since the stain was easily eliminated from the surfaces. The anti-graffiti coatings survived in limited areas after the cleaning processes, although the studied compounds are suggested as sacrificial products. Such behavior may affect the maintenance activities, when the surface is no longer protected and the coating need to be renewed, since compatibility problems, as well as harmful accumulation, could occur because of further treatments on these surfaces. (C) 2013 Elsevier B.V. All rights reserved.