In this study, shallow junction characteristics produced by implanting 2 x 10(15) cm(-2) 77 key BGe molecular ions into n-type <100> silicon wafers at liquid nitrogen temperature (LT) and room temperature (RI) were investigated. Post-annealing methods employed consisted of furnace annealing (FA) at 550 C for 0.5, 1, 2, and 3 h and rapid thermal annealing (RTA) at 1050 degrees C for 25 s. In particular, one-step (FA) and two-step (FA + RTA) post-annealing treatments were conducted. The shallow junction characteristics that were examined included junction depth, sheet resistance, crystalline recovery, and damage microstructure, and were measured using secondary ion mass spectrometry (SIMS), a four-point probe, Raman scattering spectroscopy (RSS), and cross-sectional transmission electron microscopy (XTEM), respectively. The as-implanted results revealed that the LT specimen retains a greater amount of implantation damage than the RI one does due to the occurrence of less in situ annealing in the former during ion implantation. However, the as-annealed results indicated that the shallow junction characteristics of the LT specimens are superior to those of the RT ones when annealing time in FA is greater than 1 h, which is caused by a greater solid phase epitaxial growth (SPEG) rate in the former to anneal out more damage during annealing. Notably, an annealing time of 3 h in FA is needed in order to achieve optimal crystalline recovery and electrical activation in both the one- and two-step post-annealing treatments under investigation. The same holds for both the LT and RI implantations. (C) 2014 Elsevier B.V. All rights reserved.