Membrane electrode assemblies (MEAs) were incorporated into the cathode chamber of a submersible microbial fuel cell (SMFC). A close contact of the electrodes could produce high power output from SMFC in which anode and cathode electrodes were connected in parallel. In polarization test, the maximum power density was 631 mW/m(2) at current density of 1772 mA/m(2) at 82 Omega. With 180-Omega external resistance, one set of the electrodes on the same side could generate more power density of 832 +/- 4 mW/m(2) with current generation of 1923 +/- 4 mA/m(2). The anode, inclusive a biofilm behaved ohmic, whereas a Tafel type behavior was observed for the oxygen reduction. The various impedance contributions from electrodes, electrolyte and membrane were analyzed and identified by electrochemical impedance spectroscopy. Air flow rate to the cathode chamber affected microbial voltage generation, and higher power generation was obtained at relatively low air flow less than 2 mL/min. (c) 2012 Elsevier Ltd. All rights reserved.