Chemical-Looping with Oxygen Uncoupling (CLOU) is an alternative chemical-looping process for the combustion of solid fuels with inherent CO2 capture. The CLOU process demands a material as oxygen carrier with the ability to decompose with O-2 release at suitable temperatures for solid fuel combustion, e. g. copper oxide. This article presents an experimental method to determine the maximum oxygen generation rate of an oxygen carrier as well as to determine the minimum solid inventory that must be used in the fuel reactor. The method here proposed can be used as basis for comparison of the use of different oxygen carriers or type of coals. In this work, the combustion of coal by using a promising Cu-based oxygen carrier prepared by the spray drying method was tested. The oxygen carrier (Cu60MgAl) was composed of 60 wt.% CuO and MgAl2O4 was used as supporting material. Experiments were carried out in a batch fluidized-bed reactor at temperatures ranging from 900 to 980 degrees C. Three different regions were identified depending on the oxygen carrier to coal mass ratio. For oxygen carrier to coal ratios higher than 50 (Region I), coal was fully converted to CO2 and H2O. In addition, an excess of oxygen was present in the flue gases, which was close to the equilibrium concentration. When this ratio was in the range 50-25 (Region II), the concentration of oxygen was decreasing whereas some CO was observed as the only unconverted gas. Further decrease in the oxygen carrier to coal ratio below 25 (Region III) caused the depletion of oxygen in the exhaust gases but CO remained as the only unconverted gas. CH4 or H-2 were never detected at the reactor outlet in any case and agglomeration problems were never observed. These regions were related to the solids inventory in the fuel reactor by the rate of oxygen generation calculated in every case. A maximum rate of oxygen generation for the oxygen carrier was determined as kg O-2/s per kg of oxygen carrier, which increased with the temperature from 2.1 x 10 (3) at 930 degrees C to 2.8 x 10 (3) at 980 degrees C. From these values, the estimated solids inventory in the fuel reactor was changed from 39 at 930 degrees C to 29 kg/MWth at 980 degrees C. The results obtained in this work showed that in the CLOU process it is possible to reach full conversion of the solid fuel with very low solids inventory and avoiding the oxygen polishing step. (C) 2012 Elsevier Ltd. All rights reserved.