International Journal of Hydrogen Energy, Vol.36, No.12, 7275-7283, 2011
Synthesis and characterization of Pt nanoparticles on sulfur-modified carbon nanotubes for methanol oxidation
Pt nanoparticles supported on carbon nanotubes (Pt/CNTs) have been synthesized from sulfur-modified CNTs impregnated with H(2)PtCl(6) as Pt precursor. The dispersion and size of Pt nanoparticles in the synthesized Pt/CNT nanocomposites are remarkably affected by the amount of sulfur modifier (S/CNT ratio). The results of X-ray diffraction and transmission electron microscopy indicate that an S/CNT ratio of 0.3 affords well dispersed Pt nanoparticles on CNTs with an average particle size of less than 3 nm and a narrow size distribution. Among different catalysts, the Pt/CNT nanocomposite synthesized at S/CNT ratio of 0.3 showed highest electrochemically active surface area (88.4 m(2) g(-1)) and highest catalytic activity for methanol oxidation reaction. The mass-normalized methanol oxidation peak current observed for this catalyst (862.8 A g(-1)) was similar to 6.5 folds of that for Pt deposited on pristine CNTs (133.2 A g(-1)) and similar to 2.3 folds of a commercial Pt/C (381.2 A g(-1)). The results clearly demonstrate the effectiveness of a relatively simple route for preparation of sulfur-modified CNTs as a precursor for the synthesis of Pt/CNTs, without the need for tedious pretreatment procedures to modify CNTs or complex equipments to achieve high dispersion of Pt nanoparticles on the support. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.
Keywords:Carbon nanotubes;Pt nanoparticles;Catalyst support;Methanol oxidation reaction;Sulfur;Fuel cell