International Journal of Hydrogen Energy, Vol.38, No.5, 2156-2166, 2013
Preparation of hybrid WO3-TiO2 nanotube photoelectrodes using anodization and wet impregnation: Improved water-splitting hydrogen generation performance
Hybrid tungsten trioxide-titanium dioxide (WO3-TiO2) nanotube photoelectrodes were prepared using simple anodization and wet impregnation. These hybrid nanotube photoelectrodes significantly enhanced their photoelectrochemical (PEC) water-splitting performances compared with pure TiO2 nanotube photoelectrodes. This study aims to determine the optimum soaking time in ammonium paratungstate used as the tungsten precursor for incorporating WO3 species into TiO2 nanotube photoelectrodes. A low content of WO3 species successfully diffused into the TiO2 lattice and formed W-O-Ti bonds, which significantly promoted effective charge separation by trapping photo-induced electrons from TiO2. Thus, the photocurrent density, photoconversion efficiency, STH efficiency, and H-2 generation of the resultant hybrid nanotubes were increased. However, excess WO3 species in the TiO2 nanotubes resulted in poor PEC water-splitting performance. This behavior was attributed to the large agglomerates of WO3 species were covered on the surface nanotubes that formed undesirable layers. Consequently, these undesirable layers would act as recombination sites for photo-induced electrons and holes. Copyright (C) 2012, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.