Single-phase and two-phase flow pressure drops caused by flow area expansion and contraction were measured using air and water. The test section consisted of two capillaries with 0.84 mm and 1.6 mm diameters. For single-phase flow, the Reynolds numbers defined based on the smaller diameter capillary covered the range 160-11,000. For two-phase flow, the all-liquid Reynolds number based on the smaller capillary varied in the 410-1020 range, and the flow quality varied in the 0.018-0.2 range. The single-phase flow loss coefficients for both flow area expansion and contraction were empirically correlated. For two-phase flow, the data indicated the occurrence of significant velocity slip, and the one-dimensional homogeneous flow model utterly disagreed with the data. For flow area expansion the one-dimensional slip flow model along with an Armand-type slip ratio correlation could predict the data well. For flow area contraction, the one-dimensional slip flow model along with the slip ratio expression of Zivi agreed with the data very well, provided that no venacontracta was considered. (C) 2007 Elsevier Ltd. All rights reserved.