The diffusional deposition efficiency of monomobile, singly charged nanoaerosols onto electrically grounded metal wire mesh was measured on the basis of electrometer current data The overall experimental uncertainty was of the order of 1% of measured penetration and 1% of measured particle mobility The aerosol was either WO(x), produced by evaporation/condensation and classified with a special high flow DIVA into mobility classes between 12 and 8 nm-or electrosprayed THAB ions with a mobility equivalent diameter of 144 or 176 nm for the monomer and dimer, respectively The experimental data were compared first to a model by Cheng and Yell for diffusion deposition onto wire screens Very good agreement was found down to approximately 3-4 nm, however, with a progressive deviation toward lower than predicted penetration Values (predicted by pure diffusion theory (over -25% at 1.2 nm)). The WO(x) data agree very well with penetration data obtained for THAB monomer and dimer For the larger size range above 4 nm, our data are also in excellent agreement with recent data by Thomas et al It can be concluded that, no thermal rebound effect exists for charged particles in the electrical mobility diameter size range down to 12 nm Lower than predicted penetrations measured below about 3 nm are most likely due to a small contribution by the image charge effect coupled with diffusion Comparisons between the electrical and diffusional mobility of THAB ions show that the monomer is split into at least two different electrical mobility peaks, however, with the same diffusion coefficient, thus indicating the possible existence of structural isomers for the THAB monomer (c) 2009 Elsevier Ltd All rights reserved