In industrial conditions, there are different kinds of installations endangered by an explosion of dust-gas mixtures. In order to prevent them from any consequences of potential explosions, active protection systems which use extinguishing powders, as the suppressing material, are more and more widely applied. It often happens that the industrial installations are additionally endangered by an action of mechanical vibrations. In the above-mentioned conditions, the extinguishing powder tends to aggregate, making the process of dispersing it in the protected areas more difficult. The results of research into optimization of the shape, number of igniters and miniaturization of the explosive charge mass are presented. In case of occurrence of the mechanical vibrations in the installations that cause aggregation of the suppressing powder, the best solution was modification of the perforated combustion chamber located inside the extinguisher. As a result of that, a certain amount of gases generated in the course of combustion of the main charge is directed over the membrane, where the gases crash a layer of aggregated powder. Thus, the process of pushing the powder out from a container towards the dispersing head improves considerably and consequently increases the efficiency of the explosion-suppressing process. (C) 2007 Elsevier Ltd. All rights reserved.