Explosions are the main types of accidents causing casualties in underground coal mines. Research on the mechanisms of gas explosions is needed as a basis for the development of techniques and strategies for explosion prevention, suppression, and mitigation. The prevention of loss in explosion accidents and inquiries into their causes require understanding of the explosion process of methane in air. Because of the high cost and safety issues in full scale experiments, the experiments with small scale ducts have become a key alternative approach. Whether the experimental results at small scales agree with those at full scales needs to be investigated to validate the significance of the experimental results at small scale. Numerical simulation was used to obtain the explosion characteristics of a methane-air mixture in a gallery or duct. If the grid size is too fine in the numerical simulation for a methane air explosion it is difficult to calculate using the present computer resource. If the grid size is too coarse, the considerable error may result. The effect of grid size on results of calculation depends on the scenario being investigated. The effect of grid sizes on simulation accuracy was analyzed in this work. The overpressure and temperature distributions and the flame propagation for the deflagration of methane air mixtures in a gallery or duct were obtained by the AutoReaGas code at three different scales. The geometry of investigated objects and the grids in the calculation domain were similar in the three cases. The calculated overpressures vary with the scale. The calculated temperatures do not vary with the scale for the three cases. (C) 2011 Elsevier Ltd. All rights reserved.