The bacteriophage T4 baseplate is the control center of the virus, where the recognition of an Escherichia coli host by the long tail fibers is translated into a signal to initiate infection. The short tail fibers unfold from the baseplate for firm attachment to the host, followed by shrinkage of the tail sheath that causes the tail tube to enter and cross the periplasmic space ending with injection of the genome into the host. During this process, the 6.5 MDa baseplate changes its structure from a "dome" shape to a "star" shape. An in vitro assembled hubless baseplate has been crystallized. It consists of six copies of the recombinantly expressed trimeric gene product (gp) 10, monomeric gp7, dimeric gp8, dimeric gp6 and monomeric gp53. The diffraction pattern extends, at most, to 4.0 angstrom resolution. The known partial structures of gp10, gp8, and gp6 and their relative position in the baseplate derived from earlier electron microscopy studies were used for molecular replacement. An electron density map has been calculated based on molecular replacement, single isomorphous replacement with anomalous dispersion data and 2-fold non-crystallographic symmetry averaging between two baseplate wedges in the crystallographic asymmetric unit. The current electron density map indicates that there are structural changes in the gp6, gp8, and gp10 oligomers compared to their structures when separately crystallized. Additional density is also visible corresponding to gp7, gp53 and the unknown parts of gp10 and gp6. (C) 2014 Elsevier Inc. All rights reserved.