Ti-6Al-4V alloy is the most commonly used alloy for dental and orthopedic implants. In order to improve osseointegration, different surface modification methods are usually employed, including self-assembled monolayers (SAMs). This study presents an investigation of both active (electro-assisted) and passive (adsorption) approaches for the modification of Ti-6Al-4V using alkylphosphonic acid. The monolayers were characterized by cyclic voltammetry, double-layer capacitance, contact angle measurements, X-ray photoelectron spectroscopy, polarization modulation infrared reflection adsorption spectroscopy, electrochemical impedance spectroscopy, and corrosion potentiodynamic polarization measurements. It is shown that the electrochemically assisted monolayers, which are assembled faster, exhibit better control over surface properties, a superior degree of order, and a somewhat higher packing density. The electrosorbed SAMs also exhibit better blockage of electron transfer across the interface and thus have better corrosion resistance.