With increasing requirement of steel productivity and quality in continuous casting in the conventional casting system using an immersion nozzle with side pouring holes, it is very difficult to establish a reasonable molten flow pattern(1-5)). In order to overcome this difficulty, we propose a new method imparting a swirling motion to the flow in the immersion nozzle and to control the flow pattern in the mold. Obtained results are as follows: For the case of slab continuous casting mold; High amplitudes of oscillation with a period of 10 to 15 seconds are observed in the outlet flow of the immersion nozzle and meniscus flow in the conventional casting system, while these phenomena are remarkably suppressed using swirling motion in the immersion nozzle, which leads to very calm and uniform flow pattern at the outlets of the immersion nozzle, in the mold and on the meniscus in the mold(6 - 11)). For the case of billet continuous casting mold; 1) Uniform velocity distribution can be obtained within a very short distance from the outlet of the nozzle. 2) Heat and mass transfer near the meniscus can be remarkably activated compared with a conventional straight type immersion nozzle without swirl. Those findings mentioned above are very useful to control the flow pattern in the slab, billet and bloom continuous casters.