In order to reduce pressure drop and conveying air velocity, the paper studied the effect of the dune model and soft fins in horizontal pneumatic conveying involving a 90 bend. Experimental measurements were performed in terms of the pressure drop, conveying air velocity and additional pressure drop. The distributions of particle velocity near and in the curved 90 bend were measured by high-speed PIV. The test pipeline consisted of a 4.5 m-long horizontal straight acrylic tube, a curved 90 acrylic bend (mean radius of curvature 250 mm) and a 1.5 m-long horizontal straight acrylic tube, having an inside diameter of 80 mm. The polyethylene particles with diameter of 2.3 mm were used as conveying materials. The superficial air velocity was varied from 10 to 14 m/s, and the solid mass flow rate was fixed at 0.45 kg/s. Comparing with the conventional pneumatic conveying, the pressure drop, the minimum pressure drop (MPD) velocity and additional pressure drop can be reduced by using soft fins in lower air velocity range. The reduction rates of the MPD velocity by using soft fins and dune model were about 4.1% and 83%, respectively. At the upstream of bend and in the bend, the particle velocity of using the dune model is evidently higher than that of the conventional pneumatic conveying and using soft fins. However, the effect of soft fins and dune model on the particle velocity is maintained downstream of the bend. (C) 2014 Elsevier B.V. All rights reserved.