With levelized electricity costs (LEC) of 10-12 USCts/kWh the well-known SEGS (Solar Electric Generating Systems) plants in California are presently the most successful solar technology for electricity generation [Price and Cable (2001) Proc. ASME Int. Solar Energy Conf. Forum 2001]. The SEGS plants apply a two-circuit system, consisting of the collector circuit and the Rankine cycle of the power block. These two-circuits are connected via a heat exchanger. In the case of the Direct Steam Generation (DSG) in the collector field [Zarza et al. (2001) Proc. Solar Forum 2001, Washington], the two-circuit system turns into a single-circuit system, where the collector field is directly coupled to the power block. This renders a lower investment and higher process temperatures resulting in a higher system efficiency. Due to the lower investment and the higher efficiency a reduction of the LEC of 10% is expected when the DSG process is combined with improved components of the solar collectors [Zarza (2002) DISS Phase 11 Final Report, EU Contract No. JOR3-CT98-0277]. Within the European DISS (Direct Solar Steam) project the feasibility of the direct steam generation has been proven in more than 3700 operation hours. Steam conditions of 100 bar and 400 degreesC have been demonstrated. This paper presents the main scientific results of the DISS project that aims at the investigation and demonstration of the DSG process in parabolic troughs under real solar conditions. (C) 2003 Elsevier Ltd. All rights reserved.