Evacuated tube solar collectors have better performance than flat-plate solar collectors, in particular for high temperature operations. A number of heat extraction methods from all-glass evacuated tubes have been developed and the water-in-glass concept has been found to be the most successful due to its simplicity and low manufacturing cost. In this paper, the performance of a water-in-glass evacuated tube solar pre-heater is investigated using the International Standard test method ISO 9459-2 for a range of locations. Factors influencing the operation of water-in-glass collector tubes are discussed and a numerical study of water circulation through long single-ended thermosyphon tubes is presented. Preliminary numerical simulations have shown the existence of inactive region near the sealed end of the tube which might influence the performance of the collector. (C) 2003 Elsevier Ltd. All rights reserved.